My new Widey : BRUTUS
-
- racking my brains
- Posts: 5900
- Joined: Thu Oct 06, 2005 10:46 pm
- Location: sunshine coast qld
- Contact:
what would you like close ups of??
Fibreglass airdams $370, fibreglass front bumpers $260, reco drag links $165, alloy radiators $925 (unpolished), h/l switch rebuilds $125, all plus freight.
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q
www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q
www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
-
- racking my brains
- Posts: 5900
- Joined: Thu Oct 06, 2005 10:46 pm
- Location: sunshine coast qld
- Contact:
WOULD YA BELIEVE THIS SUCKER RUNS! picked it up from the run in tune at the dyno today, just a few little fiddly jobs left to do and it'll be on the road.. and heading to gatton street sprints this year too hopefully, should be a good starion presence this year!
i took some pics a while back ix but they didnt come out very well.. spose u dont need them now anyway huh? LOL
i took some pics a while back ix but they didnt come out very well.. spose u dont need them now anyway huh? LOL
Fibreglass airdams $370, fibreglass front bumpers $260, reco drag links $165, alloy radiators $925 (unpolished), h/l switch rebuilds $125, all plus freight.
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q
www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q
www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
-
- racking my brains
- Posts: 5900
- Joined: Thu Oct 06, 2005 10:46 pm
- Location: sunshine coast qld
- Contact:
ps the exhaust note is SERIOUSLY chubby inducing :)
i built a 3 inch mild steel mandrel bent system, with a catco metal cat, flex, small straight thru muffler mounted in the recess below driver's seat, and a xforce cannon same as mine on the back, mounted straight and tucked up as high as it would go...
it sounds angry, but not farty like it would without that centre muffler.
i built a 3 inch mild steel mandrel bent system, with a catco metal cat, flex, small straight thru muffler mounted in the recess below driver's seat, and a xforce cannon same as mine on the back, mounted straight and tucked up as high as it would go...
it sounds angry, but not farty like it would without that centre muffler.
Fibreglass airdams $370, fibreglass front bumpers $260, reco drag links $165, alloy radiators $925 (unpolished), h/l switch rebuilds $125, all plus freight.
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q
www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q
www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
is the cat converter necessary for legal purposes?
quest wrote:don't try explaining that to her tho..... just leave. lolWANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
thrash wrote:is the cat converter necessary for legal purposes?
In Qld if the car came with a cat you can't delete it & if you replace the original motor with another type it must have a cat.My JB has been engineered and blue plated with the stroker,and all the twin cam mods :D
I've had mine since 03 07 92
85 JB 2323cc DOHC 4G63
THE OLDER I GET THE FASTER I WAS
GROWING OLD IS MANDATORY GROWING UP IS OPTIONAL
85 JB 2323cc DOHC 4G63
THE OLDER I GET THE FASTER I WAS
GROWING OLD IS MANDATORY GROWING UP IS OPTIONAL
side question.. did JDs come with cats?
and i wonder if it's the same in nsw, since the further south you go, the more stringent the state rules..
what if the replacement motor didn't come with a cat? do you still need to fit one?
and i wonder if it's the same in nsw, since the further south you go, the more stringent the state rules..
what if the replacement motor didn't come with a cat? do you still need to fit one?
quest wrote:don't try explaining that to her tho..... just leave. lolWANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
yesthrash wrote:side question.. did JDs come with cats?
no. Generally need to fit all emmissions equipment that were fitted to the car of new motors origin. Can't fit an engine that is older than the car (ie can't fit a 60's V8 to a Starion).thrash wrote:what if the replacement motor didn't come with a cat? do you still need to fit one?
There are exceptions to the rules - state in Aus, and LPG, but that is the gist.
4G63 - 87kg
4G54 - 107kg
4G54 - 107kg
-
- racking my brains
- Posts: 5900
- Joined: Thu Oct 06, 2005 10:46 pm
- Location: sunshine coast qld
- Contact:
you can actually fit an older engine to a newer car, but you have to fit all the emissions equipment necessary to make it pass the requirements of the newer car..
pics soon. steve took a few today when he came up.
pics soon. steve took a few today when he came up.
Fibreglass airdams $370, fibreglass front bumpers $260, reco drag links $165, alloy radiators $925 (unpolished), h/l switch rebuilds $125, all plus freight.
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q
www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q
www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
- Sargeant_Khan
- Enthusiast
- Posts: 673
- Joined: Thu Dec 16, 2004 9:31 pm
- Location: Ipswich
Yum Yum!! :drool:
Classic Touring Car racer
#20 Pre 93 touring cars
www.classictouringcars.com
RWD is for Heros, 4WD is for Zeros!
#20 Pre 93 touring cars
www.classictouringcars.com
RWD is for Heros, 4WD is for Zeros!
-
- racking my brains
- Posts: 5900
- Joined: Thu Oct 06, 2005 10:46 pm
- Location: sunshine coast qld
- Contact:
150hp atw at 6 psi at 4500rpm, without doing ignition maps..Sargeant_Khan wrote:what kind of figures bounced up on the run in tune?
ps what do you want pics of enthuzed?
Fibreglass airdams $370, fibreglass front bumpers $260, reco drag links $165, alloy radiators $925 (unpolished), h/l switch rebuilds $125, all plus freight.
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q
www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q
www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
Who is online
Users browsing this forum: No registered users and 20 guests