So seems to be no fix to problem with my Staz...

All technical questions and answers regarding starions, being modifications to maintenance.
Tamgesic
I love starions
Posts: 399
Joined: Fri Apr 17, 2009 1:27 pm
Location: Whangarei n.z

So seems to be no fix to problem with my Staz...

Post by Tamgesic »

Ive been working on this prob for weeks and weeks now.

I have been to a couple of mechanics. Also have had ideas from many of you and mates around the town.

Here is a post from a revious thread which explains what I thought it was doing at the time . .

Took me SIX hours to do a TWO hour drive at 40 km top speed farting and spluttering and back firing but yeah Im back ...

I kind of have other things I should be doing and this prob starting to make me a bit grouchy

Have done plugs, alternator, replaced any damaged leads, yesterday replaced coil, also sorted out a timing light and corrected the timing [ I had been betting it was that ..but no ] Staz really seems to be acting like timing is way out , with the distributor fully retarded im still getting 5 degrees of advance [ vacuum advance disconnected ] Tried retarding the distributor by one tooth and car would not start

today its ignitor

ANY ideas? The best way I can explain what its doing is that you put your foot down and once its past half throttle car will cough and splutter and bunny hop, wheels chirping , exhaust farting ...

also changed airflow meter...no difference.

all hoses and things are sweet.

so far have replaced
injectors
coil
coil lead
dizzy
rotor
dizzy cap
leads
plugs (correctly gapped)
alternator
fixed up the cam timing which was out by two teeth
set the dizzy up properly (it was off by 90 degrees, and all the leads were set up to suit)
wastegate actuator
checked wastegate for free movement
map sensor(factory boost guage now works perfectly and mimics my autometer exactly)

another old post:if you only have a light throttle pplication (i.e. no boost) the car will rev like normal, albeit slowly. as soon as you put your foot down, and boost goes up, it cuts out when boost hits ten psi. the factory boost guage is showing about 10 psi at the same time. taking off the car runs perfectly normally until boost comes on. have already changed the engine bay fuel filter. it really doesnt seem to be giving the symptoms of lack of fuel, until the cut.


UPDATE:.....Now it has gone back to jerking and shuddering like reaching a cut or no fuel or crap timing AS SOON as you hit boost on some occasions, other occasions car lets you reach maybe 3-5 psi before doing it .

So i go to drive car and basically as soon as hit 3000revs car will pop and slow down etc

I need to get this fixed.

Any more ideas ??
Umbrella girls rock. That is all
User avatar
panda
Enthusiast
Posts: 680
Joined: Fri Apr 18, 2008 2:56 pm
Location: Mount Gambier, South Australia

Re: So seems to be no fix to problem with my Staz...

Post by panda »

Tamgesic wrote:fixed up the cam timing which was out by two teeth
set the dizzy up properly (it was off by 90 degrees, and all the leads were set up to suit)
I'm amazed it ever ran at all set up like that :?

I'm not a mechanic, but I do know a little about electronics. I would be checking whether all the pins in the plugs & sockets are clean & making good connection in the wiring loom. Also checking that the earthing is good.
One suspicion I have is that only 1 injector is being driven, possibly due to a faulty connector or even the ECU.

Good luck,

panda
Dreams have no limits.

1982 JA - Ex Enthuzed
1982 JA - For Sale - pending
1983 JA - Ex Auto-cross car - being parted out
1983 JA - Being parted out
1984 JA - Rolling shell - For Sale
1985 JB - Rally car project
1985 JB - Autocross car
1985 JB - Week-end cruiser
redzone
racking my brains
Posts: 5900
Joined: Thu Oct 06, 2005 10:46 pm
Location: sunshine coast qld
Contact:

Post by redzone »

fuel pump/fuel filter?

popping/banging under load = lean mixture
Fibreglass airdams $370, fibreglass front bumpers $260, reco drag links $165, alloy radiators $925 (unpolished), h/l switch rebuilds $125, all plus freight.
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q

www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
User avatar
WANTSOM
Pushing my luck
Posts: 2115
Joined: Mon Jan 12, 2004 1:43 pm
Location: Sydney

Post by WANTSOM »

^^^ what he said. Was the first thing to come to my mind. It sounds like a fuel supply issue under load - check or your fuel filters, pumps and also the vacuum hoses (it doesnt take much of a hole/split to make a difference).

Good luck. :)
Never argue with an idiot, it brings you down to their level and they beat you with experience.
benny
I love starions
Posts: 464
Joined: Mon Dec 04, 2006 8:53 pm
Location: gladstone

Post by benny »

even though you replaced the sensor, try another out of a working car
tried a different ecu out of a working car?

get it on a dyno....
Image
vr4gone
I like starions more
Posts: 187
Joined: Wed May 13, 2009 1:23 pm
Location: Western Australia

Post by vr4gone »

don't forget the fuel pressure regulator.
Bitza
I've been here before
Posts: 244
Joined: Mon May 29, 2006 1:53 pm
Location: Adelaide SA

Post by Bitza »

You stated that your cam timing was out.........have you also checked your valve clearences?

If they are too tight this will also cause your trouble.
JDSTAZ45
almost postwhore
Posts: 1250
Joined: Sat Feb 12, 2005 10:00 pm
Location: Inner West, Sydney

Post by JDSTAZ45 »

Two of my imports from Japan had similar symptoms. Both have been sitting around for years and consequently
condensation builds up in the fuel tank. Tank starts to rust and flakey crap builds up in the filters and lines....
more than likely, there is water in the fuel and/or injectors are affected in some way.

I went through the rigmarole of checking plugs, leads, dizzy, hoses etc thinking my (Dash) ecu was stuffed but it was all about the fuel supply!!
Imports.
88 GSR-VR Widebody 2.6L
87 GSR-V 12V Dash 2.0L
fugazi
Enthusiast
Posts: 716
Joined: Thu Oct 02, 2008 10:30 pm
Location: Stockholm, Sweden
Contact:

Post by fugazi »

Jeeeezzz.... double posting happens ones in a while, but tripple???
rofl rofl rofl rofl rofl rofl
Image
JDSTAZ45
almost postwhore
Posts: 1250
Joined: Sat Feb 12, 2005 10:00 pm
Location: Inner West, Sydney

Post by JDSTAZ45 »

fugazi wrote:Jeeeezzz.... double posting happens ones in a while, but tripple???
rofl rofl rofl rofl rofl rofl
Oops, tried to fix it anyway!
Imports.
88 GSR-VR Widebody 2.6L
87 GSR-V 12V Dash 2.0L
Tamgesic
I love starions
Posts: 399
Joined: Fri Apr 17, 2009 1:27 pm
Location: Whangarei n.z

Post by Tamgesic »

lol the triple posting gave me a laugh haha

Wow everyone is suddenly coming up with all the ideas now!

Will try stuff mentioned above.

Had thought it was spark but initially thought it was fuel too but then mate got bit off track thinking it was maybe a timing boost cut type prob.

Hoping this will sort it .

Thanks alot
Umbrella girls rock. That is all
Colin
****WELCOME TO AUSTARION!****
Posts: 1
Joined: Sat Feb 27, 2010 5:52 am
Location: UK

Poor running

Post by Colin »

It sounds like you have a poor injector connection on one or both of them.
You might need to buy two new injector connectors and get them soldered into place. I had the same trouble on mine untill I renewed them.
They are the same as fitted on most petrol injection cars.

Regards Colin.
Tamgesic
I love starions
Posts: 399
Joined: Fri Apr 17, 2009 1:27 pm
Location: Whangarei n.z

Post by Tamgesic »

Thanks Colin will look into that.

I already swapped over all the o rings and stuff from my Ex injectors but has not seemed to be any change .
Umbrella girls rock. That is all
Tamgesic
I love starions
Posts: 399
Joined: Fri Apr 17, 2009 1:27 pm
Location: Whangarei n.z

Post by Tamgesic »

Changed the fuel pump to a bosch one

Now its just got a big whiney noise from the pump ..

...and STILL same problem

My Starion is now completely off the road and will not drive..just putts out

Having it off the road is killing me [ mainly because its my only form of transport as well ]

any more ideas????
Umbrella girls rock. That is all
JDSTAZ45
almost postwhore
Posts: 1250
Joined: Sat Feb 12, 2005 10:00 pm
Location: Inner West, Sydney

Post by JDSTAZ45 »

Whilst replacing the fuel pump, have you checked your fuel tank for moisture and/or rust and debris??

You may need to drop it, flush it out and clean all filters in tank assuming you haven't done so. Solved my problem on 2 cars!
Imports.
88 GSR-VR Widebody 2.6L
87 GSR-V 12V Dash 2.0L
Post Reply

Who is online

Users browsing this forum: No registered users and 5 guests