How to tune up my engine?

[mitstarion]

I have an 83mod starion with the 2,0l engine and want to upgrade my engine too about 300hp,but live in Norway and these cars are hard to find here.
so i hope some of you guys/girls can help me out.
really love this car!had the car in 6years now and drowed it in 4months before i started to work on it.(yeah i know...)

so pleas give me some tip and tricks

[OLD FART]

Welcome you have come to the right place as we have a couple of GURUS who seem to be able to fix/answer / point you in the right direction :) :beer

[redzone]

I have an 83mod starion with the 2,0l engine and want to upgrade my engine too about 300hp,but live in Norway and these cars are hard to find here.
so i hope some of you guys/girls can help me out.
really love this car!had the car in 6years now and drowed it in 4months before i started to work on it.(yeah i know...)

so pleas give me some tip and tricks

hi and welcome to austarion!

are we talking 300hp at the flywheel or at the wheels here?

you can crack 300hp at the flywheel with this:

1) rebuild engine with gen 1 dohc 4G63 pistons, and a good graphite or metal head gasket, arp head studs from a G54B with 10mm spacers under the nuts.

2) run an EVO3 TD05H big 16G, you will need to make a new dump pipe and mod a few little things, but you can use your stock exh manifold. look on the gtpumps.com.au site for more info. also a good 3 inch mandrel system.

3) run a good aftermarket computer and a good fuel pump, and a decent sized intercooler, a stock starion factory intercooler will do the trick. you can just get away with the stock TBI setup if running a good pump and aftermarket ecu at this power level. run it at 11.5:1 AFR under full load. would be preferable to run multipoint though for reliability.

there are cheaper ways to do it than above, but you sacrifice reliability...


multipoint manifolds can be found on efi 2.4L 4G64 8 valve vans of the early 90's.

cracking 300hp at the wheels requires a bit more. more of everything. especially money.

i have an L300 manifold for sale if you decide to go that way and cant find one over there.

[iXNAY]

or buy one of the many MPI setups for sale on here right now with your exchange rate and postage youll probably be still way infront instead of doing it all yourself

[mitstarion]

just checked out ebay:found and td05h 16g in the us for 400$
but a already have an garrett t3 with internal wastgate,will this do it?
im heading for the states in july so,i will buy what i can over there :D
but i need a new camshaft for my 2,4l head and a new manifold.Maybe custom made :drool:
300 at the flywheel is ok,,not made of moneys :(
Thanks!