another DASH problem

All technical questions and answers regarding starions, being modifications to maintenance.
Post Reply
spinners
I like starions
Posts: 144
Joined: Sat Dec 17, 2005 1:48 pm
Location: Palmerston nth new zealand

another DASH problem

Post by spinners »

hi guys,Iv got a dash motor in my starion which I used a genuine rwd motor but used a 87 eterna wiring loom eci unit etc.It runs crap with stepper motor plugged in but runs better with it unpluged but still idles erratic(good for 10sec and then crap for a couple sec)tryed swapping it and same thing,Also when you give it a sudden step on the loud pedal it farts around but later in the rev range its smooth.Any help would be appreciated :D
nzgsr
Mine is bigger than yours
Posts: 256
Joined: Wed May 31, 2006 5:16 pm
Location: auckland nz

Post by nzgsr »

sounds like what my satrion was doing with leaking injectors/orings
FST4RD
almost postwhore
Posts: 1223
Joined: Sat Dec 09, 2006 10:22 am
Location: Christchurch

Post by FST4RD »

I had more problems then you could poke a stick at with the stepper motor in my DASH engine so I unplugged it and then tightened the throttle cable to the right RPM, sometimes in the morning if it's cold you have to give it a bit of gas to get going but other then that it's fine.....

I have read that that alot of people have issues with overfueling on the DASH motors.... I know when mines at idle it spits fuel out the back a little sometimes leaving a nice wee black mark on the ground, so maybe a little to much fuel maybe until the turbo kicks in and leans things out a bit?
87_starion
Big Dorifto
Posts: 88
Joined: Wed Oct 13, 2004 3:46 pm
Location: Central AK - N.Z

Post by 87_starion »

Does your car have an o2 sensor???

Probably sounds really stupid but the missfiring problem you
describe I have experienced on a mates GTS-t. Plant your foot and
it would overfuel and cough for a moment and then come right.

We tried swapping everything from my GTS-t to his to try and sort it.
Finally, like after months of messing around it was the o2 sensor.
New o2 sensor and the thing had never driven so well.
96 R33 GTS25t - 4 Sale
02 Impreza
spinners
I like starions
Posts: 144
Joined: Sat Dec 17, 2005 1:48 pm
Location: Palmerston nth new zealand

Post by spinners »

Yes it does have an o2 sensor,the motor didnt come with one when I got it so I used one off a 88 mirage that had the same plug.IS there any way of checking it?
sirusdash
Big Dorifto
Posts: 90
Joined: Fri Jan 09, 2004 5:35 pm
Location: Hamilton

Post by sirusdash »

ok couple of things you need to check out, first most important is the O-rings for the injectors 100% sur ethese will need replacing, they have a bad habit of leaking and cause the engine to over fuel.
Also check the air flow meter is connected and working, the dash motors dotn like to run with out it.
Aslo check your Spark plug leads, I use to have a bad idle and also start farting on boost was caused by worn out leads.

If you need any other info drop me a line I might be able to help
spinners
I like starions
Posts: 144
Joined: Sat Dec 17, 2005 1:48 pm
Location: Palmerston nth new zealand

Post by spinners »

Hey SIRUS DASH did your do your wiring yourself?Cause ive got the speed sensor wire left and I dont know what to do with it?
sirusdash
Big Dorifto
Posts: 90
Joined: Fri Jan 09, 2004 5:35 pm
Location: Hamilton

Post by sirusdash »

My model is a gsr-v so its already in it, But i have done a full conversion also.
the speed senosr is on the back of the speedo, which is where your wire connects to.
the ecu willrun fine with out it, to my knowledge it just tells the ecu you are doing over 110k's and also i think it may give it fuel cut, so havig it disconnected is all good you :p
87_starion
Big Dorifto
Posts: 88
Joined: Wed Oct 13, 2004 3:46 pm
Location: Central AK - N.Z

Post by 87_starion »

haha speed cut!! whats that??? rofl
96 R33 GTS25t - 4 Sale
02 Impreza
sirusdash
Big Dorifto
Posts: 90
Joined: Fri Jan 09, 2004 5:35 pm
Location: Hamilton

Post by sirusdash »

I know I know lol :P yes mine is disconnected too, no warning tht you are doing 110k's hehe
spinners
I like starions
Posts: 144
Joined: Sat Dec 17, 2005 1:48 pm
Location: Palmerston nth new zealand

Post by spinners »

Hi again.I pulled the ECI unit apart and found the primery injector is leaking from the pintle,chucked my spear one in and that too is leaking :( .Does anyone have a good one for sale(no leaks at all)Will buy whole ECI unit if necessary.Ill put a wtb under other section.Thanks
sirusdash
Big Dorifto
Posts: 90
Joined: Fri Jan 09, 2004 5:35 pm
Location: Hamilton

Post by sirusdash »

are you using the dash injector system, if so you normally just need to replace the o-rings that surround th injectors, drop me a line if yea not sure on dismantling the unit
spinners
I like starions
Posts: 144
Joined: Sat Dec 17, 2005 1:48 pm
Location: Palmerston nth new zealand

Post by spinners »

Its is leaking from the middle of the injector-I replaced the o-rings and it dosnt leak from them. :)
spinners
I like starions
Posts: 144
Joined: Sat Dec 17, 2005 1:48 pm
Location: Palmerston nth new zealand

Post by spinners »

sorry I am using the dash ECI-I was thinking it could be the regulator that is shagged as it could be putting too much pressure through the injectors & causing them to leak :D
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests