Display your ride and post power figures, dyno runs, drag and circuit times.
-
toysrus
- 400HP by 2007!
- Posts: 2128
- Joined: Wed Feb 18, 2004 7:59 pm
- Location: adel
Post
by toysrus »
Would like to express my deep gratitude of Thanks to 'hcca' at this point as well :D
-
hcca
- Enthusiast king
- Posts: 884
- Joined: Thu Jan 08, 2004 9:24 pm
- Location: Brisbane
-
Contact:
Post
by hcca »
I want to see it with the needle at the other end of the scale before you make claims like that :)
-
toysrus
- 400HP by 2007!
- Posts: 2128
- Joined: Wed Feb 18, 2004 7:59 pm
- Location: adel
Post
by toysrus »
sshhh, I'll photochop it if you tempt me :P
-
CussCuss
- 6pack esky
- Posts: 1294
- Joined: Fri Jan 09, 2004 1:34 pm
- Location: Sydney
Post
by CussCuss »
he could have atleast spelt it right, left off the L
-
toysrus
- 400HP by 2007!
- Posts: 2128
- Joined: Wed Feb 18, 2004 7:59 pm
- Location: adel
Post
by toysrus »
Your right Cusscuss, the Cordia Rev's as sweetly as the taste of cordial on a hot summers day :P
Pull off the cross-over pipe on a Cordia and rev it to 6000rpm and believe me you'll get hooked on it :D
It also explains why I haven't bothered to hookup the Intercooler on yet too :)
Just ask Decoy
-
Junkers
- Formerly StazzyBabyYeah
- Posts: 2338
- Joined: Mon Nov 08, 2004 3:16 pm
- Location: Christchurch
Post
by Junkers »
If a cordia did 330km/hr the vast amount of wind force would squash it into the shape of a starion.
Watch your speed - It's virtually impossible to pick it out of the carpet if it gets blown off the table.
-
CussCuss
- 6pack esky
- Posts: 1294
- Joined: Fri Jan 09, 2004 1:34 pm
- Location: Sydney
Post
by CussCuss »
at the end of the day, your engine will still be facing the wrong way
-
Cookiemonster
- Mother Goose
- Posts: 3177
- Joined: Thu Jan 08, 2004 4:33 pm
- Location: Sydney
Post
by Cookiemonster »
CussCuss wrote:at the end of the day, your engine will still be facing the wrong way
It goes well with the back-to-front diff location.
-
toysrus
- 400HP by 2007!
- Posts: 2128
- Joined: Wed Feb 18, 2004 7:59 pm
- Location: adel
Post
by toysrus »
That's fine since it is a Custom Ramp/plate Differential anyway :D
-
WidebodyWoody
- Woodwide
- Posts: 3133
- Joined: Thu Jan 08, 2004 6:24 pm
- Location: Gold Coast
-
Contact:
Post
by WidebodyWoody »
The funny thing is the needle might reach the 330 mark, but the car would be up on bricks. I can't see any cordia reaching 230 let alone 330
-
Powerslave
- Mine is bigger than yours
- Posts: 282
- Joined: Sun Jan 18, 2004 1:12 am
- Location: Brisbane , Queensland
Post
by Powerslave »
I can't see any cordia reaching 230 let alone 330
I used to own an ex-chaser cordia , and believe me , they can reach 230 (with some extra weight to keep it on the road) :D
-
toysrus
- 400HP by 2007!
- Posts: 2128
- Joined: Wed Feb 18, 2004 7:59 pm
- Location: adel
Post
by toysrus »
It'll reach 330 alright, but it'll probably be flying half the time too :x
-
CussCuss
- 6pack esky
- Posts: 1294
- Joined: Fri Jan 09, 2004 1:34 pm
- Location: Sydney
Post
by CussCuss »
wait, your serious?
you think a cordia can reach 330km/h under its own power, like not being thrown off a cliff?
-
Junkers
- Formerly StazzyBabyYeah
- Posts: 2338
- Joined: Mon Nov 08, 2004 3:16 pm
- Location: Christchurch
Post
by Junkers »
I can picture a ferrari going flat tack and a cordia passing it @ 300km/hr LOL
Watch your speed - It's virtually impossible to pick it out of the carpet if it gets blown off the table.
-
toysrus
- 400HP by 2007!
- Posts: 2128
- Joined: Wed Feb 18, 2004 7:59 pm
- Location: adel
Post
by toysrus »
16" Wheels with 50 profile tyres says it can reach 320Km/hr
+ 500HP just to make sure it can cancel out the wind resistance at that speed :P
Users browsing this forum: No registered users and 39 guests