Actually mate, the new Bosch Injectors have a really improved spray pattern & idle very nicely. I know of cars with 2000cc injectors that idle like standard.
And he would have to empty the tank before putting the e-flex or e85 in and doing the flex fuel tuning. But after that, the sensor automaticaly measures the amount of ethanol in the fuel and adjusts the tune as you drive.
TOMSUN'S JB STARION - Updated 25.5.2014
The Forum Parts Guy
www.vibrantperformance.com for all your performance fabrication needs
IRS OUTLAW, 2.3L VR4 Powered X235 Drag Car
Here to run out of your life & take all your money!
www.vibrantperformance.com for all your performance fabrication needs
IRS OUTLAW, 2.3L VR4 Powered X235 Drag Car
Here to run out of your life & take all your money!
What fuel pump do you have in there now?
Aaron knows. Go for e85 + sensor + Bigger Bosch pump + Bosch injectors + new fuel line = more boost + HP
I also have a couple of Bosch fuel pumps and BOV's lying around that I don't need.
Aaron knows. Go for e85 + sensor + Bigger Bosch pump + Bosch injectors + new fuel line = more boost + HP
I also have a couple of Bosch fuel pumps and BOV's lying around that I don't need.
Please register your vehicle details on the AUSTRALIAN STARION REGISTRY <HERE>
1 x 3.2T
1 x 2.8T
3 x 2.6T's
1 x 2.0T
1 x 3.2T
1 x 2.8T
3 x 2.6T's
1 x 2.0T
I have to back off on the spending. The E85 sounds like the way to go but it's going to have to wait. Getting smashed will bills at the moment. 2 rego's turned up the same week. $1,000 for each. So I'm selling the 1991 Verada that I was using as a daily driver while working on the starion.
Took it for a drive today with a wideband LM-1. The AF ratios look good so I'm not going to worry about a re-tune with JEM for now. I'll use the Station my daily driver.
Also found an intercooler pipe had pushed its way out of the silicon joiner = major boost leak. Goes way better... Except... the wastegate is jamming and boost hits 20psi and boost cut if I keep the boot into it. I figure that wastegates are for pussys! :D
Also tempted to put in a BOV as the compressor surge is pretty evident.
Took it for a drive today with a wideband LM-1. The AF ratios look good so I'm not going to worry about a re-tune with JEM for now. I'll use the Station my daily driver.
Also found an intercooler pipe had pushed its way out of the silicon joiner = major boost leak. Goes way better... Except... the wastegate is jamming and boost hits 20psi and boost cut if I keep the boot into it. I figure that wastegates are for pussys! :D
Also tempted to put in a BOV as the compressor surge is pretty evident.
1985 JB Starion #157
no wastegate = F1 style :pimp
quest wrote:don't try explaining that to her tho..... just leave. lolWANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
Just bought a 1998 Pulsar SSS N15 Series 2 Hatchback as a daily driver so I can take the Starion off the road and do a bunch of things so it's ready (reliable) for a couple of track days.
One of the jobs is refurbishing a set of wheels. They are a set of Weds that I bought in from japan years ago. They are:
(f) 17x7.5 +16
(r) 17x8.5 +16
Currently trying to track down replacement outer lips which is proving to be very difficult as they are "40-hole".
Plan is to widen them out and assuming I have done my calculations right they should be:
(f) 17x9 -4 (225/45/17)
(r) 17x10 -4 (255/40/17) or (r) 17x9.5 +2 (245/40/17)
Just got to find the replacement parts. :roll:
And if I can't find them, I'll paint them up anyhow.
One of the jobs is refurbishing a set of wheels. They are a set of Weds that I bought in from japan years ago. They are:
(f) 17x7.5 +16
(r) 17x8.5 +16
Currently trying to track down replacement outer lips which is proving to be very difficult as they are "40-hole".
Plan is to widen them out and assuming I have done my calculations right they should be:
(f) 17x9 -4 (225/45/17)
(r) 17x10 -4 (255/40/17) or (r) 17x9.5 +2 (245/40/17)
Just got to find the replacement parts. :roll:
And if I can't find them, I'll paint them up anyhow.
Last edited by TOMSUN on Sun Jan 26, 2014 11:06 pm, edited 1 time in total.
1985 JB Starion #157
-
redzone
- racking my brains
- Posts: 5900
- Joined: Thu Oct 06, 2005 10:46 pm
- Location: sunshine coast qld
- Contact:
Buy them new from whitehorse industries?
Fibreglass airdams $370, fibreglass front bumpers $260, reco drag links $165, alloy radiators $925 (unpolished), h/l switch rebuilds $125, all plus freight.
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q
www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q
www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
a reiteration, for Shannon's benefitthrash wrote:no wastegate = F1 style :pimp
quest wrote:don't try explaining that to her tho..... just leave. lolWANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
Made 263.5 rwhp with different turbo, more boost and tune.
Just need to sort a spark issue when on boost on the street, on the Dyno it was fine. Weird.
Also did a day at a motorkhana event at Eastern creek. A great day run by www.rtdc.com.au
Just need to sort a spark issue when on boost on the street, on the Dyno it was fine. Weird.
Also did a day at a motorkhana event at Eastern creek. A great day run by www.rtdc.com.au
1985 JB Starion #157
Who is online
Users browsing this forum: No registered users and 32 guests