OLDIE at the drags

For organising a state cruise or events, posting cruise pics from the day or even event videos.
User avatar
thrash
Austarion Occupant
Posts: 3028
Joined: Mon Apr 02, 2007 10:09 pm
Location: Sydney, Australia

Post by thrash »

I hope you fix this soon. I have something for you - check your pm.
quest wrote:
WANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
don't try explaining that to her tho..... just leave. lol
OLD FART
Austarion Occupant
Posts: 3448
Joined: Sun Jun 19, 2005 1:34 pm
Location: Brisbane

Post by OLD FART »

Have PM'd you :)

Derek the "miss buster" kindly came and quickly traced it to a broken wire in the harness to the injectors . Now I have to buy a diode test light so hopefully I can trace this kind of thing in the future :)
Hopefully will be firing on all 4 again when I get the repaired harness back :D
I've had mine since 03 07 92
85 JB 2323cc DOHC 4G63
THE OLDER I GET THE FASTER I WAS
GROWING OLD IS MANDATORY GROWING UP IS OPTIONAL
User avatar
Xentro
Mine is bigger than yours
Posts: 307
Joined: Mon Jan 12, 2004 11:20 pm
Location: Holland

Post by Xentro »

Are you sure all the rollers are still in place?

I've had a faulty one jump out and it would still idle & have good compression, however when the boost came it just didn't want to go and started to stutter/ shake
-------------------------------------------
83 2000EX runner.
88 2.0 Black Widebody DOHC evo 6 turbo at 1.7 bar
88 2.6 White Widebody. spun a bearing.
06 2.0 Lancer Wagon. daily driver.
OLD FART
Austarion Occupant
Posts: 3448
Joined: Sun Jun 19, 2005 1:34 pm
Location: Brisbane

Post by OLD FART »

Rollers are ok :)
I've had mine since 03 07 92
85 JB 2323cc DOHC 4G63
THE OLDER I GET THE FASTER I WAS
GROWING OLD IS MANDATORY GROWING UP IS OPTIONAL
User avatar
Starion VR4
almost postwhore
Posts: 1293
Joined: Fri Jan 09, 2004 5:08 pm
Location: Brisbane

Post by Starion VR4 »

OLD FART wrote:Rollers are ok :)
Any update Rad?

:beer :beer
Image

30PSI,2.4L! Wolf 3D Ver 4. VR4 Head.
OLD FART
Austarion Occupant
Posts: 3448
Joined: Sun Jun 19, 2005 1:34 pm
Location: Brisbane

Post by OLD FART »

Installed a brand new set of NGK BP7RES gaped to .8mm ( 6's recommended for a stock VR4 turbo so one range colder is what is normally the go 4 modified car)started up great on all 4's so went 4 a drive for 4k or so then it gets an intermittent miss at 1800-2200 and higher so drive home into the cave and it sounds like a high lift cam with a very lopey idle :( :x :shock: :wtf: Aaargh!!!!! pull plugs do comp test again and install my used NGK Iridiums 6 heat range plugs and go for a 30 k drive and :D :D :D :D :D :D all is well again so plugs /plug faulty ??? :?
I've had mine since 03 07 92
85 JB 2323cc DOHC 4G63
THE OLDER I GET THE FASTER I WAS
GROWING OLD IS MANDATORY GROWING UP IS OPTIONAL
User avatar
Starion VR4
almost postwhore
Posts: 1293
Joined: Fri Jan 09, 2004 5:08 pm
Location: Brisbane

Post by Starion VR4 »

Rad didn't you also get the injectors cleaned that could also make it run rich.

GOOD to hear Rad. I think it's a good note for everyone that unless you have a
specific reason for running colder plugs then don't. I have seen quite a few instances

with plugs have failed when the customer is cruising around. Only to install a new set

& everything is fine again. Mitsubishi work very hard with ngk and all plug

manufactures to ensure a cracked heat range was achieved for all round

performance. Perhaps if you are doing a sprint series and maybe doing 15+ laps you might go one heat range colder , or maybe running bathurst, but day to day street

driving with the occasional performance drive standard plugs are more than adequate
Image

30PSI,2.4L! Wolf 3D Ver 4. VR4 Head.
OLD FART
Austarion Occupant
Posts: 3448
Joined: Sun Jun 19, 2005 1:34 pm
Location: Brisbane

Post by OLD FART »

Yes I had them cleaned and was thinking the same way about the AF's being a bit richer as well :)
Thanks again for coming to my rescue and sorting out the ignition miss :beer
PS don't forget about that diode tester details.
I've had mine since 03 07 92
85 JB 2323cc DOHC 4G63
THE OLDER I GET THE FASTER I WAS
GROWING OLD IS MANDATORY GROWING UP IS OPTIONAL
g_u_r_u
Big Dorifto
Posts: 79
Joined: Sun Aug 06, 2006 6:53 pm
Location: MT TAMBORINE

Post by g_u_r_u »

So my cars going ok now?

check pm
AWAITING MY INHERITANCE!!
OLD FART
Austarion Occupant
Posts: 3448
Joined: Sun Jun 19, 2005 1:34 pm
Location: Brisbane

Post by OLD FART »

Yes :D
Not quite ready to pass it on to the younger generation so be patient. :)
I've had mine since 03 07 92
85 JB 2323cc DOHC 4G63
THE OLDER I GET THE FASTER I WAS
GROWING OLD IS MANDATORY GROWING UP IS OPTIONAL
Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests