What haven't you got stashed away in your shedStarion VR4 wrote:Defiantly A Sticky !! I also have a Tig Welder if anyone need welding done in Brisbane. :beer
Rear Strut inserts - my guide
Quick update on an issue and a fix.
The rear suspension was banging when the rear suspension was unloading over bumps etc. I figured something was loose in there somewhere so I pulled one side off the car to look further into it.
On the top of the VN strut, the unthreaded part below the thread is longer than on a stock strut. When the spring cup and the strut mount were put on and the nut tightened up, the two parts are thinner than the unthreaded part on the shock. Therefore I could do the nut up tight but could never get the whole lot tight together....oops.
Solution once I figured this out is to put some washers on top, below the nut. This allows everything to be tightened properly and hopefully shouldn't move over bumps.
This shows the difference in the threaded/unthreaded part.
The rear suspension was banging when the rear suspension was unloading over bumps etc. I figured something was loose in there somewhere so I pulled one side off the car to look further into it.
On the top of the VN strut, the unthreaded part below the thread is longer than on a stock strut. When the spring cup and the strut mount were put on and the nut tightened up, the two parts are thinner than the unthreaded part on the shock. Therefore I could do the nut up tight but could never get the whole lot tight together....oops.
Solution once I figured this out is to put some washers on top, below the nut. This allows everything to be tightened properly and hopefully shouldn't move over bumps.
This shows the difference in the threaded/unthreaded part.
Who is online
Users browsing this forum: No registered users and 1 guest