WANTED (VIC) - Roll Cage

[mteck]

G'day guys,

Looking to get a bolt in roll cage made up for a JB Starion

Will be used for Drifting and must meet CAMS spec

Any advice would be super, Thanks

[1320ft]

Give this guy a call

Paul Broomfield on 0429 981 101 aka www.mrparts.com.au

Or email him at sales@mrparts.com.au

He has done heaps of cams & ANDRA cages, great work.

Just tell him your Aaron's mate for austarion

[mteck]

THANK YOU

[JJH]

As stated in the Tech section post:

http://www.bondrollbars.com/
http://www.browndavis.com.au/motorsportcages.html
http://www.rollcages.com.au/ - I have a welded cage from these guys

Plenty of others around, go to CAMS web site or get a copy of the Motorsport Manual as most of the manufacturers have ads in it.

[starionc]

As stated in the Tech section post:

http://www.bondrollbars.com/
http://www.browndavis.com.au/motorsportcages.html
http://www.rollcages.com.au/ - I have a welded cage from these guys

Plenty of others around, go to CAMS web site or get a copy of the Motorsport Manual as most of the manufacturers have ads in it.

Mtech did say Bolt in cage!

I'd check that a bolt in cage is still allowed before you spend any money mate!

My cage is a bonds welded in cage. They have all the measurements for a Starion, so you can order it over the phone. Mine was the first welded Starion cage they had done. (5 years ago now)

5 years from cage to dyno :( :( :( :( :x

Cheers
Jason

[thrash]

yeah a bolt in cage or half cage that can be removed for street duties would be nice..

do all cages cut through the dash, or can you get one that is strong enough, but goes to the floor before the dash?

[4gpwr]

http://allracefabrications.com/