JA, JB, JD
JA, JB, JD
This may have been discussed previously and has little relevance but why did Mitsi leave out JC in the models for you guys in Oz?
Also dont think there was a GSR-IV in the jap range? why?
Also dont think there was a GSR-IV in the jap range? why?
...and just what's blasphemous about my intials?MrBishi wrote:JC may seem a bit blasphemous - think about it.
Chrylser also left out the VD Valiant, went straight from VC to VE.TOMSUN wrote:similar to holden leaving out vd (venereal disease) in the commodore range
Starion nutter since 1988...
1983 JA, 1984 JA, 1985 JB (all rego'd, all running :D )
1983 JA, 1984 JA, 1985 JB (all rego'd, all running :D )
- Starion_Turbo
- Enthusiast king
- Posts: 898
- Joined: Wed Dec 08, 2004 5:32 pm
- Location: South Australia
- Contact:
- madeofmilo
- Enthusiast
- Posts: 578
- Joined: Fri May 21, 2004 5:53 pm
- Location: Melb - East
The JD MODEL HAD LESS POWER DUE TO ULP GAS, DIFFERENT FRONT & REAR SPOILERS A 3.9 DIFF ,HORIZONTALLY MOUNTED FRONT MOUNT INTERCOOLER ,WAS SLOWER & DIFFERENT TRIM (only app 50 sold in Aust )GRZHOPR wrote:Ok, stupid American question here... Can someone please explain to me the differences among the JA, JB, and JD models?
Thanks.
i'm sure someone will come up with anything I've missed /forgotten
I've had mine since 03 07 92
85 JB 2323cc DOHC 4G63
THE OLDER I GET THE FASTER I WAS
GROWING OLD IS MANDATORY GROWING UP IS OPTIONAL
85 JB 2323cc DOHC 4G63
THE OLDER I GET THE FASTER I WAS
GROWING OLD IS MANDATORY GROWING UP IS OPTIONAL
-
- almost postwhore
- Posts: 1131
- Joined: Tue Jan 25, 2005 10:46 pm
- Location: Mackay, QLD, Australia
The JD intercoolers are mounted vertically like normal. Have never seen a horizontal one in a car, only in drawings in mitsubishi manuals.
My car was dead stock original and the cooler was mounted vertical.
JD also apprantly has the bigger diff and a smaller TC-05 turbo. The washer bottles in the front are also slightly different to suit the intercooler pipes.
JA
-125kw 2.0L 4G63 SOHC non-intercooled Leaded Fuel
-MHI TC06 oil-cooled turbo
-Type 1 Throttle body injection
-Vented and scooped bonnet
-3.55:1 open diff
-Leather front seats vynil rear seats
-Manual mirrors
-Power windows (buttons on centre console, no lock button)
-Series 1 JA have radio antenna on roof above driver
-Series 2 JA have radio antenna on rear passanger quarter above fuel filler
-Series 1 JA have lock on fuel filler door (no release inside the car)
-Series 2 JA have release for fuel door beside driver seat
-14 inch mags
-Twin B-pillar on each side. vents mounted flush
-Front air dam mounted close to front wheels
-Hatch mounted spoiler made from foam and rubber
JB
-125kw 2.0L 4G63 SOHC non-intercooled Leaded Fuel
-MHI TC06 oil-cooled and water-cooled turbo
-Type 2 Throttle body injection
-Flat bonnet
-3.55:1 open diff or optional 3.55:1 LSD (most seem LSD)
-Velour interior
-Power mirrors
-Power windows (im unsure on button placement)
-Radio antenna on rear passanger quarter above fuel filler
-JB have release for fuel door beside driver seat
-15 inch mags (same as JD)
-Single B-pillar vent on each side angled rearward and come out of the car a bit
-Front air dam mounted close to front wheels
-Hatch mounted spoiler made from foam and rubber
JD
-110kw 2.0L 4G63 SOHC intercooled ULP
-MHI TC05 oil-cooled and water-cooled turbo
-Cat converter in exhaust
-Type 2 Throttle body injection
-Flat bonnet
-3.9:1 LSD (all factory LSD)
-Velour interior
-Different steering wheel to JA
-Power mirrors (buttons on centre console)
-6 Speaker stereo (2 in dash, 2 in doors, 2 in rear)
-Power windows with buttons placed on each door (lock button on drivers side)
-Radio antenna on rear passanger quarter above fuel filler
-JD have release for fuel door beside driver seat
-15 inch mags (same as JB)
-Single B-pillar vent on each side angled rearward and come out of the car a bit
-Large airdam that houses intercooler, small ducts on each side.
-3 peice rear wings (widebody style) that got on hatch and each quarter
My car was dead stock original and the cooler was mounted vertical.
JD also apprantly has the bigger diff and a smaller TC-05 turbo. The washer bottles in the front are also slightly different to suit the intercooler pipes.
JA
-125kw 2.0L 4G63 SOHC non-intercooled Leaded Fuel
-MHI TC06 oil-cooled turbo
-Type 1 Throttle body injection
-Vented and scooped bonnet
-3.55:1 open diff
-Leather front seats vynil rear seats
-Manual mirrors
-Power windows (buttons on centre console, no lock button)
-Series 1 JA have radio antenna on roof above driver
-Series 2 JA have radio antenna on rear passanger quarter above fuel filler
-Series 1 JA have lock on fuel filler door (no release inside the car)
-Series 2 JA have release for fuel door beside driver seat
-14 inch mags
-Twin B-pillar on each side. vents mounted flush
-Front air dam mounted close to front wheels
-Hatch mounted spoiler made from foam and rubber
JB
-125kw 2.0L 4G63 SOHC non-intercooled Leaded Fuel
-MHI TC06 oil-cooled and water-cooled turbo
-Type 2 Throttle body injection
-Flat bonnet
-3.55:1 open diff or optional 3.55:1 LSD (most seem LSD)
-Velour interior
-Power mirrors
-Power windows (im unsure on button placement)
-Radio antenna on rear passanger quarter above fuel filler
-JB have release for fuel door beside driver seat
-15 inch mags (same as JD)
-Single B-pillar vent on each side angled rearward and come out of the car a bit
-Front air dam mounted close to front wheels
-Hatch mounted spoiler made from foam and rubber
JD
-110kw 2.0L 4G63 SOHC intercooled ULP
-MHI TC05 oil-cooled and water-cooled turbo
-Cat converter in exhaust
-Type 2 Throttle body injection
-Flat bonnet
-3.9:1 LSD (all factory LSD)
-Velour interior
-Different steering wheel to JA
-Power mirrors (buttons on centre console)
-6 Speaker stereo (2 in dash, 2 in doors, 2 in rear)
-Power windows with buttons placed on each door (lock button on drivers side)
-Radio antenna on rear passanger quarter above fuel filler
-JD have release for fuel door beside driver seat
-15 inch mags (same as JB)
-Single B-pillar vent on each side angled rearward and come out of the car a bit
-Large airdam that houses intercooler, small ducts on each side.
-3 peice rear wings (widebody style) that got on hatch and each quarter
-JA Starion with JD bits , Forged engine, Heaps of mods (parked up)
-BFII XR6 Turbo Ute , Here comes 400hp for 2k :p
-77 Mazda 323 drag car. 13bt rotary project.
Yes i have too many toys.
SOHC POWER
-BFII XR6 Turbo Ute , Here comes 400hp for 2k :p
-77 Mazda 323 drag car. 13bt rotary project.
Yes i have too many toys.
SOHC POWER
JA
-Series 1 JA have radio antenna on roof above driver
-Series 2 JA have radio antenna on rear passanger quarter above fuel filler
-Series 1 JA have lock on fuel filler door (no release inside the car)
-Series 2 JA have release for fuel door beside driver seat
hmm I have antenna on roof, and release beside drivers seat?
JB
-Power windows - on door trims
-Series 1 JA have radio antenna on roof above driver
-Series 2 JA have radio antenna on rear passanger quarter above fuel filler
-Series 1 JA have lock on fuel filler door (no release inside the car)
-Series 2 JA have release for fuel door beside driver seat
hmm I have antenna on roof, and release beside drivers seat?
JB
-Power windows - on door trims
1983 JA Staz
Who is online
Users browsing this forum: No registered users and 16 guests