My twincam conversion

[greenstaz82]

Hi everyone jsut thought id share a few photos of some of the progress on my conversion . Ive just finished modifying my firewall to make way for the water pipe and cas , for someone thinking of goin down this road its a very easy job . Where the cas hits the firewall its actually double panel so by removing the outa bit with the raised section gives u plenty of clearance . i just tidyed it up with a few stitches of weld and some bog .

[/img]
And heres just a few other photos of stuff . I was very lucky to come across someone selling a conversion package that gave me pretty much everything i need to covert it , thermostat housing , exhaust manifold , modified intake , turbo etc etc . So most of the hard work has already been done . :D

[/img]

[/img]

[silo]

Thats lookin awesome buddy :D
Im doin the same conversion so this is very useful info for me, thanks heaps :beer

[TWIMCAM BOY]

that awesome mate good luck with the finishing it! i like it a lot
what turbo and ecu ya running?

[greenstaz82]

ive got a gt30 40 for it and external wastegate not sure what ecu im running yet as i havent purchased one yet .... thinkin maybe haltech ???

[compressor]

any chance of a pic or rear thermostat housing pipe up close? did you get a pipe made or buy 1 for it? any pics to doriften@yahoo.com please

[greenstaz82]

yeah i actually brought the whole set up off someone elses project , looks to me its all been custom made and alot of work has gone into it , ill put some pics up of it all set up in place .

[SIR GSR]

I've got a GReddy Emanage if you need an ECU.... ;)

That set up looks damn nice....Congrats on the find

[greenstaz82]

heres the thermostat housing piping , ill take some others once i get the motor out .

[/img]

hey thanks for the offer SIR GSR , ive got some money to spend in other places first but ill keep it in mind :beer

[compressor]

thanks mate :beer what is the alloy peice for with the earls fitting for ?? where does that fitting go to ?? sorry for all the questions its just im at the same point and dont know what way to go

[greenstaz82]

hey im brand new to it all too :) just learning along the way . yeah thats the remote thermostat housing and the fitting will be a water source for my turbo . also holes have been drilled and tapped into the thermostat housing to run all the factory sensors .

[compressor]

heres mine so far[img]Show%20Image:%20[img]http://www.fr33z3.net/starions/Apr06/pi ... _copy1.jpg[/img][/img]

[compressor]

sorry about the big pic im new to that too :o

[TWIMCAM BOY]

another awesome twincam gee s there are alot more conversion then i ever thought :D hope the national starion meet happens next year!!!!

[greenstaz82]

mad shit !!!! what sort of turbo is that? looks pretty big , im in the middle of painting my engine bay at the moment got everything out . gotta send my motor away to get assembled properly , also gettting my balance shafts deleted and timing belt tensioner modified . then hopefully it will go back in for the last time lol . u running a wide or narrow block in that thing ?

[compressor]

hks 3037 turbo turbosmart 45mm progate scat rods aries pistons fully balanced and blueprinted motor stainless oring block and tripple layer headgasket no balance shafts microtech bosch044 fuel pump and all the other waste of money parts needed to get the stazza going fast rofl