don't know you guys do this much, i'm wanting to give it a try because it will make for much shorter intercooler piping when i get around to it.
basically (from what i can find out) you make up a spacer plate and turn the whole ECI unit through 90ish degrees so the inlet is facing the front of the car.
i could pull everything apart and just jump in with both feet but i figured i'd try and see if anybody on here has done it, what results they had (good and bad) and hopefully somebody will have a diagram or something of what i pretty much need to do.
anyway, here's a pic of what i want to do in case it doesn't all make sense (not my car, damn it):
cheers
Matt
turning the ECI unit
turning the ECI unit
project 1: 1976 TA23 Celica
project 2: 1981 EX Lancer, SOHC 4G63T conversion, heaps of turbo lancer bits, running, but fixing the diff at the moment :D
project 2: 1981 EX Lancer, SOHC 4G63T conversion, heaps of turbo lancer bits, running, but fixing the diff at the moment :D
- Powerslave
- Mine is bigger than yours
- Posts: 282
- Joined: Sun Jan 18, 2004 1:12 am
- Location: Brisbane , Queensland
with the skinny looking throttle bodys on the later cars, they had some sorta air diverter plate.... I suppose to help the wet manifold with its already poor distribution. The consensus (at least on the u.s. forums) is to leave it alone and not 'make bad worse'... or lotsa folks would have done so already
i thought the US starions ran different engines? like the 2.6's???
the english guys have had some success with rotating the ECI unit, although some of the were cutting and welding the inlet pipe to move it and this didn't do so well, issues with fuel distribution i think.
i've only heard good things about using a spacer plate though, i've been emailed a job plan of one if anybody's interested??? i could email it on to anyone, just leave an email address.
i might pull mine apart this week and see about this water thing. my engine's out of a galant but i was under the impression that its exactly the same as the 8 valve starion motors anyway. i'll take some pics as i do it and let people know how it goes.
cheers
Matt
the english guys have had some success with rotating the ECI unit, although some of the were cutting and welding the inlet pipe to move it and this didn't do so well, issues with fuel distribution i think.
i've only heard good things about using a spacer plate though, i've been emailed a job plan of one if anybody's interested??? i could email it on to anyone, just leave an email address.
i might pull mine apart this week and see about this water thing. my engine's out of a galant but i was under the impression that its exactly the same as the 8 valve starion motors anyway. i'll take some pics as i do it and let people know how it goes.
cheers
Matt
project 1: 1976 TA23 Celica
project 2: 1981 EX Lancer, SOHC 4G63T conversion, heaps of turbo lancer bits, running, but fixing the diff at the moment :D
project 2: 1981 EX Lancer, SOHC 4G63T conversion, heaps of turbo lancer bits, running, but fixing the diff at the moment :D
Who is online
Users browsing this forum: No registered users and 13 guests