WTB - VR4 Timing belt cover and plate

WANTSOM · Post by **WANTSOM** » Fri Jul 10, 2009 2:42 pm

This is a bit left of centre but does anyone have the plastic timing belt cover (lower half only) and the metal plate that sits behind the idler pulley off a VR4. [New ex Mitsi is super expensive and ex wrecker Hyundai is a PITA to remove all the front clip to get to the part when working in 2 inches of finger room).

If anyone has one lying around from an old project or whatever it would be for a goood cause, happy to pay a reasonable fee.

Tks
Greg

JAS · Post by **JAS** » Sun Jul 12, 2009 4:13 pm

I tried to find a second hand one of these for my starion. But gave up and bought a new one. Apparently the cambelts chew them out a lot.

redzone · Post by **redzone** » Sun Jul 12, 2009 7:02 pm

$300 worth of plastic welding and repairs on steve's one was half the price of a new one..

MR Bender · Post by **MR Bender** » Sun Jul 12, 2009 8:52 pm

let me look in my shed i think i have one in there!

JAS · Post by **JAS** » Mon Jul 13, 2009 5:15 am

Im sure I only paid $170 ish for my one.....

redzone · Post by **redzone** » Mon Jul 13, 2009 6:13 am

probably a lot cheaper across the ditch. also would be shitloads more of em floating around..

Adriano · Post by **Adriano** » Mon Jul 13, 2009 6:26 pm

90% of the ones i have had anything to do with have been chewed out in one way or the other. The other 10% are on my three twincams

WANTSOM · Post by **WANTSOM** » Mon Jul 13, 2009 9:58 pm

JAS · Post by **JAS** » Mon Jul 27, 2009 6:03 am

Are you still looking for the plastic cambelt cover? Found one in my garage. Its a little chewed out near the oil pump drive, but very usable. Oh and its gray not black. I got it off a twin cam non turbo 4g63.
Or I can get you a brand new one for $200NZD plus shipping.

Austarion

WTB - VR4 Timing belt cover and plate

WTB - VR4 Timing belt cover and plate

Who is online