bosch ignition upgrade

[hollandgalant]

Hi there,

I have doen the igntition module upgrade from Bosch but the car is not starting.

I have measured the voltage on the negative side of the coil and I am measuring only 2,6 volt. According to the manual it says that or the dizzy is broken or the coil is broken.

My question how can I test my dizzy? or is there something else perhaps wrong with my setup? When I measure the voltage on the + side of the ignition module going to the dizzy (pin 7) I measure 0,8 volts. I measure exactly the same on the negative side of the ignition module going to the dizzy (pin 3) also 0.8 volt with the ignition on.

Any help would be appreciated.

Regards,

Johan