wtf.. starion sputerring at high revs

All technical questions and answers regarding starions, being modifications to maintenance.
Post Reply
reedys1
Dorifto!
Posts: 66
Joined: Wed Oct 15, 2008 6:52 pm
Location: wa

wtf.. starion sputerring at high revs

Post by reedys1 »

ok so she runs fine under normal driving. but if you give her too much gas at high revs she'll sputter and carry on at about 3500 - 4000 revs only under boost. is my turbo shagged it doesn't seem to cut off goes into the red boost gauge and stays there. eg.. fast acceleration from first to second normaly i can get over70 - 80km no worries but now it sputters and carries on while under boost if i drop down from third into second at high revs theres no problem. running stock starion ja 82 set up no modifications.
WidebodyWoody
Woodwide
Posts: 3133
Joined: Thu Jan 08, 2004 6:24 pm
Location: Gold Coast
Contact:

Post by WidebodyWoody »

Sounds like your hitting the fuel cut. This happens if you are trying to run more then I think 8psi of boost? I can't remember the exact psi or bar, but yeah, there are a few ways to trick it, but safest way is to install a fuel cut defender. Search the forums for it.

IF you are running stock boost, make sure you aren't accidently running more, by checking the vacuum hose going from the actuator to the turbo. And make sure the vacuum hose going to the MAP sensor is good and not split.
User avatar
panda
Enthusiast
Posts: 680
Joined: Fri Apr 18, 2008 2:56 pm
Location: Mount Gambier, South Australia

Post by panda »

Had a similar problem. Turned out to be a stuck waste-gate on the turbo, which over boosted, which made the fuel mixture go lean, which caused the 'fuel cut' feature to kick in.
Dreams have no limits.

1982 JA - Ex Enthuzed
1982 JA - For Sale - pending
1983 JA - Ex Auto-cross car - being parted out
1983 JA - Being parted out
1984 JA - Rolling shell - For Sale
1985 JB - Rally car project
1985 JB - Autocross car
1985 JB - Week-end cruiser
NachoMan
nearly postwhore
Posts: 1589
Joined: Sat Jan 10, 2004 12:28 pm
Location: Perth (Morley), WA
Contact:

...

Post by NachoMan »

Check to see what your boost gauge is doing when it starts spluttering.
It could be your MAP sensor...
redzone
racking my brains
Posts: 5900
Joined: Thu Oct 06, 2005 10:46 pm
Location: sunshine coast qld
Contact:

Post by redzone »

yep most likely overboost (over 13psi) or faulty map sensor. could also be as simple as plug leads.
Fibreglass airdams $370, fibreglass front bumpers $260, reco drag links $165, alloy radiators $925 (unpolished), h/l switch rebuilds $125, all plus freight.
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q

www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
reedys1
Dorifto!
Posts: 66
Joined: Wed Oct 15, 2008 6:52 pm
Location: wa

Post by reedys1 »

cheers guys, hey nachoman :D :D :D can i get you to hae a quick look at it on sunday for the cruise not sure about map sensors etc :oops: :oops: . but yeah i think it must have something to do with the boost being outta wack should just be set at stock psi. when she is spluttering the boost gauge is maxed out. :wtf: :wtf: :wtf:
WidebodyWoody
Woodwide
Posts: 3133
Joined: Thu Jan 08, 2004 6:24 pm
Location: Gold Coast
Contact:

Post by WidebodyWoody »

Yeah I had this problem many times. Was never the same issue. I just had it about 1 year ago on the widey, and it was because a lead had a slight hole in it and was shorting against my dump
NachoMan
nearly postwhore
Posts: 1589
Joined: Sat Jan 10, 2004 12:28 pm
Location: Perth (Morley), WA
Contact:

...

Post by NachoMan »

Yep, we'll take a look on sunday.
9:30am at the address that I PM'd you about...
enthuzed
Austarion Occupant
Posts: 3578
Joined: Tue Apr 06, 2004 1:21 pm
Location: Melborno
Contact:

Post by enthuzed »

Got the same sorta problem with mine as well, all stock setup too...will check this out further at some stage soon. It's not the leads, they're basically brand new, doubt it's the wastegate but I'll check it again.
Reduce fuel costs by 15-20% & cut emissions by 1/3rd...
Increase engine performance & prolong engine life...
How?
Click the website button below & watch the 3 minute video.
User avatar
MR Bender
Enthusiast king
Posts: 754
Joined: Sun Nov 11, 2007 8:01 pm
Location: Perth Western Australia (SOR)

Post by MR Bender »

in steves case (reedys) it was the pipe broken from the turbo to wastegate just check to see what the boost does!
Bite my shiny metal ass!!!

Russell Coight: Some of the animals are nocturnal, so the best time to see them is at night. Only you can't see them, because it's dark.
Post Reply

Who is online

Users browsing this forum: No registered users and 6 guests