http://www.ebay.com.au/itm/270922316049 ... 500wt_1413
L300 manifold goes on ebay on Thursday 1st of March. This link will be active after then. Last chance to grab it.
Sydney August Garage Sale
-
Bruzman
- I like starions
- Posts: 125
- Joined: Thu Dec 29, 2011 3:10 pm
- Location: Port Macquarie NSW AUS
I heard the L300 is an easy manifold conversion if you aren't going DOHC. Tho, I know some of the manifold's you need to customise the throttle body so that the Throttle cable will work. Is this type pretty much Bolt-on compared to the others?thrash wrote:http://www.ebay.com.au/itm/270922316049 ... 500wt_1413
L300 manifold goes on ebay on Thursday 1st of March. This link will be active after then. Last chance to grab it.
Work on Car, Go to Gym, Pump Bitches = Life
Yes the 300 manifold is the easiest to use BUT the Gallant/Hyundai is far better.Bruzman wrote:I heard the L300 is an easy manifold conversion if you aren't going DOHC. Tho, I know some of the manifold's you need to customise the throttle body so that the Throttle cable will work. Is this type pretty much Bolt-on compared to the others?thrash wrote:http://www.ebay.com.au/itm/270922316049 ... 500wt_1413
L300 manifold goes on ebay on Thursday 1st of March. This link will be active after then. Last chance to grab it.
FYI/FWIW I had a custom plenum and runners bolted to the bottom 1/2 of a 300.
So ultimately it's up to you as to how far you want to go.
I've had mine since 03 07 92
85 JB 2323cc DOHC 4G63
THE OLDER I GET THE FASTER I WAS
GROWING OLD IS MANDATORY GROWING UP IS OPTIONAL
85 JB 2323cc DOHC 4G63
THE OLDER I GET THE FASTER I WAS
GROWING OLD IS MANDATORY GROWING UP IS OPTIONAL
the L300 manifold is easier to fit, but not as good at making a lot of power as the sonata manifold is, due to the plenum being much smaller.
the challenges with the sonata manifold are:
- you will need to block off the throttle body side of it and cut the opposite side and attach the throttle body there, so that it faces forward on a north-south mounted motor, as in our starions and any rear drive mitsu.
- You will need a longer pipe from the intake to the radiator, and this pipe full of hot water will tend to heat up your intake charge a tad perhaps.
If I remember correctly, the L300 will be good for about 150-160ish rwkw before it becomes a choking point, where the sonata manifold and net you maybe about 20rwkw more.
To overcome this, the l300 can be installed to complete the mpi upgrade, and then modded with a larger plenum later down the track - this is better than the sonata manifold - perhaps the best MPI setup, as you can make the plenum larger for more power, and the water piping is closer to the radiator top hose
the challenges with the sonata manifold are:
- you will need to block off the throttle body side of it and cut the opposite side and attach the throttle body there, so that it faces forward on a north-south mounted motor, as in our starions and any rear drive mitsu.
- You will need a longer pipe from the intake to the radiator, and this pipe full of hot water will tend to heat up your intake charge a tad perhaps.
If I remember correctly, the L300 will be good for about 150-160ish rwkw before it becomes a choking point, where the sonata manifold and net you maybe about 20rwkw more.
To overcome this, the l300 can be installed to complete the mpi upgrade, and then modded with a larger plenum later down the track - this is better than the sonata manifold - perhaps the best MPI setup, as you can make the plenum larger for more power, and the water piping is closer to the radiator top hose
quest wrote:don't try explaining that to her tho..... just leave. lolWANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
Last chance to grab this L300 manifold - auction ends Sunday 2:30-3pm Sydney time!
http://www.ebay.com.au/itm/270922316049 ... 500wt_1413
http://www.ebay.com.au/itm/270922316049 ... 500wt_1413
quest wrote:don't try explaining that to her tho..... just leave. lolWANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
Who is online
Users browsing this forum: No registered users and 54 guests