Quickest Starions in Australia & NZ
-
- racking my brains
- Posts: 5900
- Joined: Thu Oct 06, 2005 10:46 pm
- Location: sunshine coast qld
- Contact:
yeah man on the old nokia 6630 haha..
both those runs were with the KKR430 on 18psi. and full street trim with a half tank of fuel and all interior intact etc, street tyres as i mentioned.. and u might wanna update i have forged JE VR4 pistons no balance shafts since the engine rebuild august last year.. and a U12 bluebird intercooler with modified end tanks as i had 2 let the JD cooler go with the roll cage car when i sold it..
both those runs were with the KKR430 on 18psi. and full street trim with a half tank of fuel and all interior intact etc, street tyres as i mentioned.. and u might wanna update i have forged JE VR4 pistons no balance shafts since the engine rebuild august last year.. and a U12 bluebird intercooler with modified end tanks as i had 2 let the JD cooler go with the roll cage car when i sold it..
Fibreglass airdams $370, fibreglass front bumpers $260, reco drag links $165, alloy radiators $925 (unpolished), h/l switch rebuilds $125, all plus freight.
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q
www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q
www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
AXLER8 has 1.6 second 60 foot FARK!!!!!!!! must have slicks!
With slicks i might get into the low 12's with a restrictor!
TOMSUN
My car has standard cams and is running about 17PSI then falls over to about 7PSI at the top end caused by the 36mm RESTRICTOR. The turbo is a Garrett GT2871 R, with the 36 mm restrictor 50mm away from the inpeller blades
Ash
With slicks i might get into the low 12's with a restrictor!
TOMSUN
My car has standard cams and is running about 17PSI then falls over to about 7PSI at the top end caused by the 36mm RESTRICTOR. The turbo is a Garrett GT2871 R, with the 36 mm restrictor 50mm away from the inpeller blades
Ash
Get Stroked! 2.3ltr EVO engine
i believe the setup has been inspected and sealed somehow to qualify for his racing... if he took it out the seal would be broken and he'd have to get it inspected again... unless he chucks a completely new turbo on it!
_
_________________
_________________
I can confirm that AXLER8 ran that 60ft & elapsed time with NO slicks and an open diff :beerBarney wrote:AXLER8 has 1.6 second 60 foot FARK!!!!!!!! must have slicks!
With slicks i might get into the low 12's with a restrictor!
Ash
Computer games don't affect kids I mean if PacMan affected us as kids, we'd all be running around in darkened rooms, munching magic pills and listening to repetitive electronic music :D
True Storydecoy wrote:i believe the setup has been inspected and sealed somehow to qualify for his racing... if he took it out the seal would be broken and he'd have to get it inspected again... unless he chucks a completely new turbo on it!
To remove it is not a problem But. To to refit it and having it inspected involves presenting the turbo to CAMS (not fitted to the car)
Get Stroked! 2.3ltr EVO engine
toysrus wrote:I can confirm that AXLER8 ran that 60ft & elapsed time with NO slicks and an open diff :beerBarney wrote:AXLER8 has 1.6 second 60 foot FARK!!!!!!!! must have slicks!
With slicks i might get into the low 12's with a restrictor!
Ash
Pulling a 1.6s 60 foot time, it should be good for a high 11s... open diff? WOW!
1985 JB Starion #157
Barney,
You have the GT2871R
***********************
Garrett GT2871R 390hp or 440hp ball bearing turbo
This turbo is the next step to the GT28RS Disco Potato with the same basic configuration but with a larger 71mm comp wheel.
These units are available in 48 and 56 trim, with the 56 trim rated at 440hp potential. They come with the .86 exhaust housing as standard, but can be optioned with the .64 housing subject to availability.
*************************
I was looking to get that turbo...
What trim do you have??
what exhaust housing do you have???
What would it be like on the street? Peeky power or broad range?
When does it start to make boost?
:beer
You have the GT2871R
***********************
Garrett GT2871R 390hp or 440hp ball bearing turbo
This turbo is the next step to the GT28RS Disco Potato with the same basic configuration but with a larger 71mm comp wheel.
These units are available in 48 and 56 trim, with the 56 trim rated at 440hp potential. They come with the .86 exhaust housing as standard, but can be optioned with the .64 housing subject to availability.
*************************
I was looking to get that turbo...
What trim do you have??
what exhaust housing do you have???
What would it be like on the street? Peeky power or broad range?
When does it start to make boost?
:beer
1985 JB Starion #157
-
- Enthusiast
- Posts: 737
- Joined: Wed Feb 02, 2005 2:46 pm
- Location: oregon, USA
- Contact:
Yeah some luck was surely involved, all the other runs he did that day were in the 2.X 60ft zone.airbats801 wrote:how the hell do you pull a 1.6 60ft with open diff and no slicks? I take it you are running some street legal autox tires or something?
Computer games don't affect kids I mean if PacMan affected us as kids, we'd all be running around in darkened rooms, munching magic pills and listening to repetitive electronic music :D
Luck!!! "Lucky I found that extra grip and power... Maybe it was hiding in my ashtray all along..." LUCK????toysrus wrote:Yeah some luck was surely involved, all the other runs he did that day were in the 2.X 60ft zone.airbats801 wrote:how the hell do you pull a 1.6 60ft with open diff and no slicks? I take it you are running some street legal autox tires or something?
I wouldn't be supprised if he staged his car with the rear wheels... expecially to have such a big difference in 60' times!!!
Or that is someone elses time slip... They can get mixed up...
1985 JB Starion #157
Who is online
Users browsing this forum: No registered users and 43 guests