Top Mount Intercooler vs. Front Mount
- Starion_Turbo
- Enthusiast king
- Posts: 898
- Joined: Wed Dec 08, 2004 5:32 pm
- Location: South Australia
- Contact:
hi
A 2.5" silicone fits nicley onto the t/b if squashed on.
I used a 2.5" 90 and cut it on an angle to achive a greater than 90 degree bend and a dip out of the sides makes it fit nug up against the t/b.
As I used 2.25" piping needed the end flaired to 2.5" to match the silicone.
A 2.5" silicone fits nicley onto the t/b if squashed on.
I used a 2.5" 90 and cut it on an angle to achive a greater than 90 degree bend and a dip out of the sides makes it fit nug up against the t/b.
As I used 2.25" piping needed the end flaired to 2.5" to match the silicone.
Powerplant: Chipped stock ECU, 2044cc, 8.5:1, head intake enlarged and polished, exhaust manifold enlarged,
Balance-shafts eliminated, Intercooled, TC06 @ 10psi, 2.5" high flow exhaust system and dump pipe.
Balance-shafts eliminated, Intercooled, TC06 @ 10psi, 2.5" high flow exhaust system and dump pipe.
Who is online
Users browsing this forum: No registered users and 17 guests