Jet Valve Elimination Kit
These studs replace the spring mechanisim for the Jet Valve to they can't open.
$48 for pack of 4 through REPCO
Jet Valve Elimination Kit (pic)
Jet Valve Elimination Kit (pic)
1985 JB Starion #157
- jakobsladderz
- Mine is bigger than yours
- Posts: 286
- Joined: Wed Feb 11, 2004 10:32 pm
- Location: Ballarat
Hey tomsun,
What was the part # at repco, I rang the local repco here and the guy I talked to didn't have a clue about them..
What was the part # at repco, I rang the local repco here and the guy I talked to didn't have a clue about them..
Trispen - A form of intelligent grass. It grows a single, tough stalk and makes its home on lawns. When it sees the lawnmower coming it lies down and pops up again after it has gone by. (Douglas Adams, The Meaning of Liff)
JA Starion - Mechanic's Training and on-road EFI testing laboratory.
JA Starion - Mechanic's Training and on-road EFI testing laboratory.
CHEAPER
If you post the part number i will price them for you guys. should be a fair bit cheaper.
El-Jayz Speed Shop sells a great selection engine internals, Turbo Chargers, Waste-Gates, Intercoolers, Manifolds, Blow-Off Valves, Boost Controllers, Fuel pumps, Injectors, Pipe Work, Silicone Hoses, T-Bolt Clamps, Gaskets etc.
-
- [P] Plates
- Posts: 32
- Joined: Mon Jun 05, 2006 1:36 am
- Location: USA
- Contact:
these and the jet valve are made of steel, which will cause hot spot
in the combustion chamber. i would take 1 to a local machinist and have him turn a few from billet aluminum, use thread lok to seal it in or if you head is off the engine have them welded in. this will keep from creating a hot spot for detonation,head cracking.
in the combustion chamber. i would take 1 to a local machinist and have him turn a few from billet aluminum, use thread lok to seal it in or if you head is off the engine have them welded in. this will keep from creating a hot spot for detonation,head cracking.
those that can follow keep up,those who cant leave them
hmm... ?
They are off a similar material to the great big valves that are there as well as the spark plug tip.
If I was really worried about it I would just get a non jet valve head off an L300 van. (Prolly cheaper than getting aluminium jet valve)
And when welding a head there is always a risk of that part of the head going soft due to melting the head and changine the material properties.
They are off a similar material to the great big valves that are there as well as the spark plug tip.
If I was really worried about it I would just get a non jet valve head off an L300 van. (Prolly cheaper than getting aluminium jet valve)
And when welding a head there is always a risk of that part of the head going soft due to melting the head and changine the material properties.
1985 JB Starion #157
Who is online
Users browsing this forum: No registered users and 8 guests