Slow Power Window
Slow Power Window
Hi
Would appreciate comments on reason for slow operation of passenger power window.
The driver's side (important side!!) works fine up and down however other side is slower going down and even slower going up.
Expert comments appreciated.
Cheers
Ric
Would appreciate comments on reason for slow operation of passenger power window.
The driver's side (important side!!) works fine up and down however other side is slower going down and even slower going up.
Expert comments appreciated.
Cheers
Ric
Slow Power Window
Thanks Alpos I'll grease up pole and see what happens. I wouldn't really bother with this issue as its not on MY side however the other half might get edgy if the passenger side window stops working!!
Cheers
Ric
Cheers
Ric
-
- I like starions more
- Posts: 177
- Joined: Fri Dec 30, 2005 11:41 am
- Location: Whangarei, NZ
Slow Power Window
Thanks for that. I have removed door panel and greased the pole as Alpos suggested. If that doesn't fix it I will check out wiring. What should I look for?? Is it fraying or just old age. Did you use a multimeter and if so what values did you check??
A common problem in some bands of cars, is the cable running between the door frame and car chassis gets worn out due to the door openning all the time. The cable breaks down between those points and can no longer carry the full current to supply the motor. this some times can be checked by feeling the cable which will get hot after making the window go up and down a few times. Otherwise feed anotehr heavy duty cable between the switch and motor to test hope that helps
-
- I like starions more
- Posts: 177
- Joined: Fri Dec 30, 2005 11:41 am
- Location: Whangarei, NZ
multimeter showed up nothing other than a large voltage drop on window motor actuation (which would be expected) . i did the old fashioned "bypass the wiring" in sections until i found which part was causing the fault.
There was no visible fault
There was no visible fault
Last edited by plasticdash on Fri Mar 31, 2006 9:40 am, edited 1 time in total.
Slow Power Window
Thanks chaps. I'll check our the cable as suggested and also try the bypass wiring. I reckon I now have all the ammunition to fix this problem. Thanks again.
Cheers
Ric
Cheers
Ric
The window wiring in both my Starions was farken dodgy so it may well be that.. both cars had burnt out wires in the window circuit that had been replaced at some point in the distant past - one was burnt out all the way from the relay box in the engine bay right up to the switch :roll:
With my Sigma that I converted Magna power windows into, I ended up wiring them up with relays which worked great.
With my Sigma that I converted Magna power windows into, I ended up wiring them up with relays which worked great.
Slow Power Window
I didn't realise my power window would create so much interest. The window seems to operating better after "greasing the pole" and I haven't tried the wiring yet.
What is this new development about "cogs rubbing against the door shields". Surely they shouldn't do that and why do they?
The plot thickens!!!
Cheers Ric
What is this new development about "cogs rubbing against the door shields". Surely they shouldn't do that and why do they?
The plot thickens!!!
Cheers Ric
Hmm, I ended up greasing the pole but found it made no difference so I continued playing around with other things.
I just sprayed some CRC into the small holes in the side where I could see cogs turning (the gearing on the arm and the cog between that and the motor), It was only the gear on the arm that looked to be rubbing up against the door.. perhaps it wasn't but the CRC made a noticable difference.
I just sprayed some CRC into the small holes in the side where I could see cogs turning (the gearing on the arm and the cog between that and the motor), It was only the gear on the arm that looked to be rubbing up against the door.. perhaps it wasn't but the CRC made a noticable difference.
Watch your speed - It's virtually impossible to pick it out of the carpet if it gets blown off the table.
Who is online
Users browsing this forum: No registered users and 5 guests