JB carbon firbre bonnet

Technical questions and ideas regarding how your Starion looks inside and out, bodykits to stereos.
Post Reply
User avatar
Chryzla
Princess
Posts: 1320
Joined: Wed May 19, 2004 6:26 pm
Location: Adelaide, SA
Contact:
Contact Chryzla

Post by Chryzla »

are you talking about the tiny slit holes?

my bonnet just has small holes that wouldnt do a thing..
1983 JA Staz
Top
evoJB
I like starions more
Posts: 187
Joined: Wed Jun 22, 2005 10:50 am
Location: Gold Coast

Post by evoJB »

the vents arent totally blocked, BUT, they have only very small slits, which should probably count as being blocked off... :wink:
Starion Powered By EVO
220.5kw/atw
Top
sLug
Big Dorifto
Posts: 72
Joined: Fri Jan 13, 2006 1:00 pm
Location: Adelaide

Post by sLug »

Neither my scoop or the small vents on my bonnet are blocked but i dont know if it has been removed or not cause I only have the heat shielding above my turbo. :D
Top
User avatar
Defective
Enthusiast
Posts: 706
Joined: Thu Apr 15, 2004 10:43 pm
Location: Nelson, South island
Contact:
Contact Defective

Post by Defective »

main scoop is blocked from the factory, those little bitty slits wont do much because of the sound deadening/heat protection shit that stuck on the bonnet...
and the little side vents have a rubber strip that blocks the actual vent, once you throw that away you still have to drill holes in your bonnet to let air in/out...
Top
pro gsr
Big Dorifto
Posts: 80
Joined: Thu Aug 18, 2005 9:38 pm
Location: brisbane.QLD

JB carbon firbre bonnet

Post by pro gsr »

i had a JA with the inside of the bonnet cut out. where the vents are.
so as to vent air in/ out. looked rough did the job.

should have kept it too. ahhh
mitsubishi starion jd 1985, factory intercooler,
custom stainless intercooler pipe work,to4 compressor wheel,10 psi boost,boost controller, 2 & half inch exhaust with stainless muffler 4 inch tip, 15 inch mags
Top
Post Reply

Return to “Body & Interior Mods”

Who is online

Users browsing this forum: No registered users and 0 guests