WTB:starion turbo parts
-
- [P] Plater austaz
- Posts: 24
- Joined: Thu Nov 10, 2005 4:04 pm
- Location: ballarat
WTB:starion turbo parts
hi need a starion turbo computer and wiring loom if possible and if anyone has a pollution cannister with all the hoses attached i would be interested also and any intercoolers and gauges
-
- [P] Plater austaz
- Posts: 24
- Joined: Thu Nov 10, 2005 4:04 pm
- Location: ballarat
starion stuff
can u post a pic of wat u got im not too stressed about the loom as i can get an auto elec to wire it up
- Starion VR4
- almost postwhore
- Posts: 1293
- Joined: Fri Jan 09, 2004 5:08 pm
- Location: Brisbane
wire
Do yrself a favour, DON"T USE THE STD INJECTION SYSTEM, if yr going to get it rewired buy a aftermarket ECU(Wolf3d Ver4) & use that, it's better value and U can tune it, :beer
30PSI,2.4L! Wolf 3D Ver 4. VR4 Head.
-
- [P] Plater austaz
- Posts: 24
- Joined: Thu Nov 10, 2005 4:04 pm
- Location: ballarat
-
- almost postwhore
- Posts: 1015
- Joined: Sat Jan 10, 2004 12:02 pm
- Location: Ballarat, Victoria, Australia
- Contact:
sigmaturbo, i have a computer and a loom (may have had a couple of wires cut, can't remember).
However, I will recommend you going for an aftermarket computer like a wolf or a microtech which are both quite cheap fuel+ignition systems, just over a grand new, or there's some cheaper ones which only do fuel. Either would be much better than the standard computer.
You can use them with the standard injection, or what a few people do is get either an l300 (yes, the van) mpi manifold or a hyundai sonata 2.4l mpi manifold and use that. They bolt straight onto the head, the hyundai will need the throttle body moved to the other side of the plenun, but that's it.
if you'd like to check out mine (i have a l300 on my car), then send me a pm, i'm not far from ballarat.
However, I will recommend you going for an aftermarket computer like a wolf or a microtech which are both quite cheap fuel+ignition systems, just over a grand new, or there's some cheaper ones which only do fuel. Either would be much better than the standard computer.
You can use them with the standard injection, or what a few people do is get either an l300 (yes, the van) mpi manifold or a hyundai sonata 2.4l mpi manifold and use that. They bolt straight onto the head, the hyundai will need the throttle body moved to the other side of the plenun, but that's it.
if you'd like to check out mine (i have a l300 on my car), then send me a pm, i'm not far from ballarat.
Who is online
Users browsing this forum: No registered users and 15 guests