I have a starting problem. the starter motor wiends over just no spark in the coil ignition lead.
The distributor internal wires are o.k
Is the coil at fault?
How can i find the fault?
cheers from Tom
JD starting problem
JD starting problem
mitsubishi starion jd 1985, factory intercooler,
custom stainless intercooler pipe work,to4 compressor wheel,10 psi boost,boost controller, 2 & half inch exhaust with stainless muffler 4 inch tip, 15 inch mags
custom stainless intercooler pipe work,to4 compressor wheel,10 psi boost,boost controller, 2 & half inch exhaust with stainless muffler 4 inch tip, 15 inch mags
- Starion VR4
- almost postwhore
- Posts: 1293
- Joined: Fri Jan 09, 2004 5:08 pm
- Location: Brisbane
-
- OoOhhh BabY
- Posts: 69
- Joined: Fri Mar 05, 2004 10:38 am
- Location: gold coast
start
ye 4 sure ignitor box they a bit dodgy think cordia uses same box.cheers
-
- Harmful or fatal if swallowed
- Posts: 1582
- Joined: Fri Sep 26, 2003 1:50 am
- Location: Perth
- Contact:
Re: no spark
Hey Tom, How are ya?Starion VR4 wrote:yr ignition igniter is stuffed... call me tom :beer
---------
TVR T350C
TVR T350C
JD starting problem
problem fixed.
i checked if the coil had power to the wires on both sides of the coil it does have power to the wires, i checked with a test light. also checked the fusible links, with the test light, & relays next to them to see if any have disconnected abit. i just pushed the relays down to make sure.
& replaced the ignition lead from the coil to the distributor.
car starts now good stuff.
cheers from Tom
i checked if the coil had power to the wires on both sides of the coil it does have power to the wires, i checked with a test light. also checked the fusible links, with the test light, & relays next to them to see if any have disconnected abit. i just pushed the relays down to make sure.
& replaced the ignition lead from the coil to the distributor.
car starts now good stuff.
cheers from Tom
mitsubishi starion jd 1985, factory intercooler,
custom stainless intercooler pipe work,to4 compressor wheel,10 psi boost,boost controller, 2 & half inch exhaust with stainless muffler 4 inch tip, 15 inch mags
custom stainless intercooler pipe work,to4 compressor wheel,10 psi boost,boost controller, 2 & half inch exhaust with stainless muffler 4 inch tip, 15 inch mags
Who is online
Users browsing this forum: No registered users and 8 guests