JD starion motor

notty1978 · Post by **notty1978** » Tue Oct 05, 2004 9:41 am

HI Everyone
Does anyone know of a good motor for my JD starion i need one
I want some thing that has some balls to it and will not want to play up on me.
or should i just get my old 4g63t motor rebuilt it does idle but blows smoke alot it was stolen and shannons car insurence will not fix it for me
WHAT SHOULD I DO
any help would be good
thanks
notty :(
notty1978@kooee.com.au

dirty sanchez · Post by **dirty sanchez** » Tue Oct 05, 2004 10:45 am

I'd just get your motor rebuilt. New pistons, rings and bearings and it'll be almost as good as new.

notty1978 · Post by **notty1978** » Tue Oct 05, 2004 7:34 pm

WHAT ABOUT A BETTER MOTOR FOR THE CAR

tmz_99 · Post by **tmz_99** » Tue Oct 05, 2004 7:46 pm

hmm, check out thetech section, but u have a range of upgrade options for ur current motor, then u have the 2.6 astron, the DASH motor, the DOHC, then u can go away from the mitsubishi and do a 2JZ or a rotart or SR20.. really its up to you WHAT you stick in there, its all about how much ur willing to spend, but unless your budget is around the 8-10k mark stick with the motor you have in there now.

NachoMan · Post by **NachoMan** » Tue Oct 05, 2004 9:07 pm

rebuild what you got.

Or stick a Galant VR4 or EVO III motor in it. Lot's of $$$ though.

Anything else is just silliness...

JPC · Post by **JPC** » Tue Oct 05, 2004 10:29 pm

There seems to be a 'law of diminishing returns' when it comes to engine swaps, regardless of the type of car :)

According to legend, if you go for an engine swap (regardless of how little you spend on obtaining the new engine), you'll always spend around $10K by the time you're finished and road-ready...

Got $10K?

If you haven't, get your existing engine rebuilt - will save both time and money...

dirty sanchez · Post by **dirty sanchez** » Wed Oct 06, 2004 8:56 am

If you do it yourself you can do an SR20DET for about $4500 (not including engineer report). It's certainly cheaper to rebuild your current engine.

fr335tyl3r · Post by **fr335tyl3r** » Wed Oct 06, 2004 9:09 am

How much does a full rebuild of an engine usually set you back? Im looking at options at the moment.

Post by **Alspos** » Wed Oct 06, 2004 9:27 am

Depends on what you get done. Standardish rebuild would be in the order of 2k, forgies, rods, stud kits etc. would add to the cost.
Ring Coltspeed or BTL or whoever and ask the question, that's what they are there for. But have an idea of what you want to get out of it.

notty1978 · Post by **notty1978** » Wed Oct 06, 2004 8:11 pm

Thanks guys i might get a rebuilt then
i was told you could get a 4g63t motor for around $1000
i will do my motor up
what is some good gear to get for my motor that will not cost a arm and a leg
thanks
notty

WANTSOM · Post by **WANTSOM** » Wed Oct 06, 2004 9:32 pm

Refer Alspos' post. Coltspeed in Sydney 02 9807 3830.

Austarion

JD starion motor

JD starion motor

...

Who is online