Sherminator's Staz ::Update::
Sherminator's Staz ::Update::
The engine is out cause for some reason it didnt want to run with 700ml of oil. Seized oil pump and the balance shaft aint moving in a hurry.
Pulled the engine down also to have a geezer of what was in there.
Changed the springs over to some lowered ones so it dont look so gay with the 18's on it.
New steering wheel too as the old one got farked when the yobbos tried to flog the car.
Plenty more to come as we piece it all back together and i remove all the rice when he's not looking
Pulled the engine down also to have a geezer of what was in there.
Changed the springs over to some lowered ones so it dont look so gay with the 18's on it.
New steering wheel too as the old one got farked when the yobbos tried to flog the car.
Plenty more to come as we piece it all back together and i remove all the rice when he's not looking
Last edited by MrGenius on Thu Nov 18, 2004 10:15 am, edited 3 times in total.
Re: The Sherminator's Staz pulled down [www.18u]
Like the headlight switches?MrGenius wrote:Plenty more to come as we piece it all back together and i remove all the rice when he's not looking
Re: The Sherminator's Staz pulled down [www.18u]
Dont worry we have all payed him out about his replacement headlight switches :D The old ones flew out the window while driving through the M5 tunnel when he switched them off roflAlspos wrote:Like the headlight switches?MrGenius wrote:Plenty more to come as we piece it all back together and i remove all the rice when he's not looking
LxS
Sticker will most likely be removed in favour of one of mine :D
Springs for starion 40mm lowered $270 for all 4 plus postage PM me if ya interested :)
- Cookiemonster
- Mother Goose
- Posts: 3177
- Joined: Thu Jan 08, 2004 4:33 pm
- Location: Sydney
the ones stiffler supplied (mr genius) are 1 1/2 inch front 2inch rear if not low enough for you you can get them reset very cheap but they are set at that height id say cause it handles best there. You guys can laugh at my light switches but think of this it cost me $30 to fix compared to $330 for the genuine ones
Take a measurement from the centre of your wheel to the guard all around and put the measurements up here then if someone with a stocker height one could do the same u can figure it out :)LxS wrote:Very Interested -
But I have a problem, my starion has 'choped' springs curtousy of the the previous owner, and I need new springs all round but dont have a clue how low it has been dropped ?
-
- almost postwhore
- Posts: 1015
- Joined: Sat Jan 10, 2004 12:02 pm
- Location: Ballarat, Victoria, Australia
- Contact:
They are Dobinsons springs.Will wrote:What brand are those springs MrGenius? and do you have a ride height measurement for them when fitted?
I can check the heights but they wont be very accurate as the car hasnt moved so the springs wont have settled, plus there is no engine in the car so the front is sky high :) I'll get a few of the boys to get in the engine bay and make 4G63 noises and measure the height.
Who is online
Users browsing this forum: No registered users and 3 guests