Sherminator's Staz ::Update::

Display your ride and post power figures, dyno runs, drag and circuit times.
MrGenius
Big Dorifto
Posts: 73
Joined: Thu Jun 03, 2004 7:46 pm
Location: Sydney
Contact:

Sherminator's Staz ::Update::

Post by MrGenius »

The engine is out cause for some reason it didnt want to run with 700ml of oil. Seized oil pump and the balance shaft aint moving in a hurry.

Image

Pulled the engine down also to have a geezer of what was in there.

Image

Changed the springs over to some lowered ones so it dont look so gay with the 18's on it.

Image

New steering wheel too as the old one got farked when the yobbos tried to flog the car.

Image

Plenty more to come as we piece it all back together and i remove all the rice when he's not looking
Last edited by MrGenius on Thu Nov 18, 2004 10:15 am, edited 3 times in total.
User avatar
Alspos
Flucking kwankers
Posts: 4107
Joined: Thu Jan 08, 2004 2:09 pm
Location: Melbourne
Contact:

Re: The Sherminator's Staz pulled down [www.18u]

Post by Alspos »

MrGenius wrote:Plenty more to come as we piece it all back together and i remove all the rice when he's not looking
Like the headlight switches?
User avatar
LxS
I love starions
Posts: 416
Joined: Thu Jan 08, 2004 1:43 pm
Location: Sydney, Australia

Post by LxS »

Nice car, are you taking the huge sticker off the front too?

BTW: How much did your springs set you back if you dont mind me asking, PM if it's private. Can you get discounts :D
8 2 ' M i t s u b i s h i S t a r i o n W i d e b o d y
MrGenius
Big Dorifto
Posts: 73
Joined: Thu Jun 03, 2004 7:46 pm
Location: Sydney
Contact:

Re: The Sherminator's Staz pulled down [www.18u]

Post by MrGenius »

Alspos wrote:
MrGenius wrote:Plenty more to come as we piece it all back together and i remove all the rice when he's not looking
Like the headlight switches?
Dont worry we have all payed him out about his replacement headlight switches :D The old ones flew out the window while driving through the M5 tunnel when he switched them off rofl

LxS
Sticker will most likely be removed in favour of one of mine :D

Springs for starion 40mm lowered $270 for all 4 plus postage PM me if ya interested :)
User avatar
Cookiemonster
Mother Goose
Posts: 3177
Joined: Thu Jan 08, 2004 4:33 pm
Location: Sydney

Post by Cookiemonster »

What types of missiles can you launch from that dash?
MrGenius
Big Dorifto
Posts: 73
Joined: Thu Jun 03, 2004 7:46 pm
Location: Sydney
Contact:

Post by MrGenius »

rofl
decoy
Let Me Out!
Posts: 4424
Joined: Tue Sep 09, 2003 3:03 pm
Location: Far from home
Contact:

Post by decoy »

rofl

sweeeeeeet, missile switches :P pow pow! *whisltels* BOOOOOOM
_
_________________
User avatar
LxS
I love starions
Posts: 416
Joined: Thu Jan 08, 2004 1:43 pm
Location: Sydney, Australia

Post by LxS »

Very Interested -

But I have a problem, my starion has 'choped' springs curtousy of the the previous owner, and I need new springs all round but dont have a clue how low it has been dropped ?
8 2 ' M i t s u b i s h i S t a r i o n W i d e b o d y
User avatar
www.18u
almost postwhore
Posts: 1112
Joined: Tue May 18, 2004 12:31 am

Post by www.18u »

the ones stiffler supplied (mr genius) are 1 1/2 inch front 2inch rear if not low enough for you you can get them reset very cheap but they are set at that height id say cause it handles best there. :wink: You guys can laugh at my light switches but think of this it cost me $30 to fix compared to $330 for the genuine ones
Image
User avatar
MelbStazz
Enthusiast king
Posts: 866
Joined: Thu Jan 08, 2004 2:55 pm
Location: Melbourne

Post by MelbStazz »

My switches died as well, i pulled the dash apart got the switches out, and glued them back together. 18 months down the track and they're still good as new. The missle switches give it a unique look.
:D
- el schmicko detailer -
MrGenius
Big Dorifto
Posts: 73
Joined: Thu Jun 03, 2004 7:46 pm
Location: Sydney
Contact:

Post by MrGenius »

LxS wrote:Very Interested -

But I have a problem, my starion has 'choped' springs curtousy of the the previous owner, and I need new springs all round but dont have a clue how low it has been dropped ?
Take a measurement from the centre of your wheel to the guard all around and put the measurements up here then if someone with a stocker height one could do the same u can figure it out :)
User avatar
Will
Mine is bigger than yours
Posts: 333
Joined: Sun Jan 11, 2004 10:30 am
Location: Sydney
Contact:

Post by Will »

My ride height is 320mm rear, 305mm front. That's wheel centre to guard lip. Can someone post their stock ride heights please. I'm interested to know how much drop my car has.

What brand are those springs MrGenius? and do you have a ride height measurement for them when fitted?
Chris 83JA
almost postwhore
Posts: 1015
Joined: Sat Jan 10, 2004 12:02 pm
Location: Ballarat, Victoria, Australia
Contact:

Post by Chris 83JA »

very rough measurements:
355 back
335 front

in the dark, with a torch and a ruler
MrGenius
Big Dorifto
Posts: 73
Joined: Thu Jun 03, 2004 7:46 pm
Location: Sydney
Contact:

Post by MrGenius »

Will wrote:What brand are those springs MrGenius? and do you have a ride height measurement for them when fitted?
They are Dobinsons springs.

I can check the heights but they wont be very accurate as the car hasnt moved so the springs wont have settled, plus there is no engine in the car so the front is sky high :) I'll get a few of the boys to get in the engine bay and make 4G63 noises and measure the height.
MrGenius
Big Dorifto
Posts: 73
Joined: Thu Jun 03, 2004 7:46 pm
Location: Sydney
Contact:

Post by MrGenius »

Just waiting for the forgies to come then we can put the engine back together and start bolting on all the goodies :)

For those who wanted the sticker removed

Image

And ...

Image
Post Reply

Who is online

Users browsing this forum: No registered users and 22 guests