Gearbox

All technical questions and answers regarding starions, being modifications to maintenance.
Post Reply
Kano
[L] Plates
Posts: 10
Joined: Mon May 31, 2004 8:09 pm
Location: SA

Gearbox

Post by Kano »

has anyone else experienced problems with starion gearbox. about a month ago it started when its warm its a bitch to get it into second gear, clunks hard but okay when its cold. also gearstick shakes around in all gears, am i missing something cause it makes a very annoying rattle n im always holding it to shut the thing up. its always been damn shaking
User avatar
merlin
Enthusiast
Posts: 658
Joined: Sun Jan 11, 2004 5:51 pm
Location: Sydney, Australia

Post by merlin »

remove your tunnel console so you can check the top shifter bolts.
or possibly the shifter is detaching itself from the mechanism. its a rubber bond to the actual shift lever into the gearbox.
and dont get any hypoi gearbox oil on your carpet, itl stink for years.
while your there, might as well replace the old oil with some Redline MTL.
very good stuff!
User avatar
Alspos
Flucking kwankers
Posts: 4107
Joined: Thu Jan 08, 2004 2:09 pm
Location: Melbourne
Contact:

Post by Alspos »

Check engine and gearbox mounts, could be the whole lot moving around.
User avatar
SpidersWeb
postwhore!
Posts: 1984
Joined: Wed Jan 28, 2004 2:29 am
Location: Wellington, NZ

Post by SpidersWeb »

When warm the only difference is the oil is everywhere, and lubricating properly. I can't downchange to 2nd gear until it has warmed up.

So Im going to put in my recommendation to have your manual transmission fluid changed - as you may find a piece of 2nd gear in it that is getting banged around when the fluid has warmed up.

Im no gearbox genius here, its just an idea that makes sense to me.
1997 Mitsubishi Lancer Evolution IV 4G63BT
1996 Nissan Maxima VQ30DE (for sale, suit someone who likes the feel of boats when driving)
User avatar
Cookiemonster
Mother Goose
Posts: 3177
Joined: Thu Jan 08, 2004 4:33 pm
Location: Sydney

Re: Gearbox

Post by Cookiemonster »

Kano wrote:has anyone else experienced problems with starion gearbox. about a month ago it started when its warm its a bitch to get it into second gear, clunks hard but okay when its cold. also gearstick shakes around in all gears, am i missing something cause it makes a very annoying rattle n im always holding it to shut the thing up. its always been damn shaking
Does it start shaking at around 3000rpm. If so you could have a balance shaft problem.
DJ_NoVa
Dorifto!
Posts: 52
Joined: Wed Jan 14, 2004 8:55 pm
Location: Melbourne
Contact:

Post by DJ_NoVa »

How would on change gearbox oil...
never done it and never seen it done,
is it
a. just as straight forward as a engine oil change?
b. more ocmplicated because of the removing of interior bits?
or c. shouldn't be tried unless instructed or supervised?

or does any one care to share the steps?

cheers,
"No problem can be solved from the same level of consciousness that created it".
- Albert Einstein
decoy
Let Me Out!
Posts: 4424
Joined: Tue Sep 09, 2003 3:03 pm
Location: Far from home
Contact:

Post by decoy »

DJ_NoVa wrote:How would on change gearbox oil...
never done it and never seen it done,
is it
a. just as straight forward as a engine oil change?
b. more ocmplicated because of the removing of interior bits?
or c. shouldn't be tried unless instructed or supervised?

or does any one care to share the steps?

cheers,
i beleive its the same as engine oil. undo the bolt at the bottom, oil comes out. however getting the oil back in is a bit trickier, for obvious reasons. i think there is a bolt on the side of the box, alongside the underside of the car, that you use to fill it back up. the only problem is to get the oil in, you'll need to pump it in (syringe) or run a hose to it, hold the other end of the hose upright by the side of the car and fill it from there.
_
_________________
User avatar
SIRIUS
Enthusiast
Posts: 587
Joined: Sun Jan 11, 2004 12:19 pm
Location: adelaide

Post by SIRIUS »

cookie can you also get an extra 20hp from removing gearbox balance shafts....LOL....u make me laugh
Valiant VJ E55 Charger
Valiant VK E57 Wagon
Valiant VF VIP 318 Fireball
Valiant VF-X hemi
Mitsubishi JA Starion

---------- THE MOPAR MAN ----------
User avatar
GADGET
I love starions
Posts: 489
Joined: Mon May 24, 2004 9:27 pm
Location: Adelaide, SA

Post by GADGET »

I had that vibration in my silver car when I first got it.

I had no idea what it was so off to the mechanic. They said most likely a stuffed engine mount. It turned out to be that one of the belts to the balance shaft had skipped off at one end, or it skipped a few teeth and wasn't in the right position to the rest of the engine.
It was a few years back now.

The dude I bought it from covered it up by having his hand on the gear stick
User avatar
Cookiemonster
Mother Goose
Posts: 3177
Joined: Thu Jan 08, 2004 4:33 pm
Location: Sydney

Post by Cookiemonster »

SIRIUS wrote:cookie can you also get an extra 20hp from removing gearbox balance shafts....LOL....u make me laugh
Without ENGINE balance shafts the vibration will be transferred through the gearbox and the gearstick will rattle like crazy.
Last edited by Cookiemonster on Tue Aug 03, 2004 10:55 pm, edited 1 time in total.
Chris 83JA
almost postwhore
Posts: 1015
Joined: Sat Jan 10, 2004 12:02 pm
Location: Ballarat, Victoria, Australia
Contact:

Post by Chris 83JA »

you can fill up the gearbox oil inside your car by removing the centre console and shifter...
can't you?
ProZac
G33Kz0r
Posts: 2674
Joined: Thu Nov 27, 2003 1:26 pm
Location: Christchurch, New Zealand
Contact:

Post by ProZac »

If you cant, where the hell did all that oil go!?
User avatar
Barney
Scorpion King
Posts: 929
Joined: Fri Jan 09, 2004 1:24 pm
Location: Perth WA

Post by Barney »

Lube guide recomends mineral 75w/90

ASHLY
Get Stroked! 2.3ltr EVO engine
DJ_NoVa
Dorifto!
Posts: 52
Joined: Wed Jan 14, 2004 8:55 pm
Location: Melbourne
Contact:

Post by DJ_NoVa »

cheers boys i'm on my way,
got wat the castrol book recomended,
85/90 diff oil
and syntrax gear oil,
may as well change the rest while i'm at it...
at a pretty penny i must add...
"No problem can be solved from the same level of consciousness that created it".
- Albert Einstein
Kano
[L] Plates
Posts: 10
Joined: Mon May 31, 2004 8:09 pm
Location: SA

Same shit gadget

Post by Kano »

Yeah im always holding the gear knob to stop it hell vibrating n making that hella annoying noise. did u fix it yourself? how easy was it?
Post Reply

Who is online

Users browsing this forum: No registered users and 31 guests