Gearbox
Gearbox
has anyone else experienced problems with starion gearbox. about a month ago it started when its warm its a bitch to get it into second gear, clunks hard but okay when its cold. also gearstick shakes around in all gears, am i missing something cause it makes a very annoying rattle n im always holding it to shut the thing up. its always been damn shaking
remove your tunnel console so you can check the top shifter bolts.
or possibly the shifter is detaching itself from the mechanism. its a rubber bond to the actual shift lever into the gearbox.
and dont get any hypoi gearbox oil on your carpet, itl stink for years.
while your there, might as well replace the old oil with some Redline MTL.
very good stuff!
or possibly the shifter is detaching itself from the mechanism. its a rubber bond to the actual shift lever into the gearbox.
and dont get any hypoi gearbox oil on your carpet, itl stink for years.
while your there, might as well replace the old oil with some Redline MTL.
very good stuff!
- SpidersWeb
- postwhore!
- Posts: 1984
- Joined: Wed Jan 28, 2004 2:29 am
- Location: Wellington, NZ
When warm the only difference is the oil is everywhere, and lubricating properly. I can't downchange to 2nd gear until it has warmed up.
So Im going to put in my recommendation to have your manual transmission fluid changed - as you may find a piece of 2nd gear in it that is getting banged around when the fluid has warmed up.
Im no gearbox genius here, its just an idea that makes sense to me.
So Im going to put in my recommendation to have your manual transmission fluid changed - as you may find a piece of 2nd gear in it that is getting banged around when the fluid has warmed up.
Im no gearbox genius here, its just an idea that makes sense to me.
1997 Mitsubishi Lancer Evolution IV 4G63BT
1996 Nissan Maxima VQ30DE (for sale, suit someone who likes the feel of boats when driving)
1996 Nissan Maxima VQ30DE (for sale, suit someone who likes the feel of boats when driving)
- Cookiemonster
- Mother Goose
- Posts: 3177
- Joined: Thu Jan 08, 2004 4:33 pm
- Location: Sydney
Re: Gearbox
Does it start shaking at around 3000rpm. If so you could have a balance shaft problem.Kano wrote:has anyone else experienced problems with starion gearbox. about a month ago it started when its warm its a bitch to get it into second gear, clunks hard but okay when its cold. also gearstick shakes around in all gears, am i missing something cause it makes a very annoying rattle n im always holding it to shut the thing up. its always been damn shaking
How would on change gearbox oil...
never done it and never seen it done,
is it
a. just as straight forward as a engine oil change?
b. more ocmplicated because of the removing of interior bits?
or c. shouldn't be tried unless instructed or supervised?
or does any one care to share the steps?
cheers,
never done it and never seen it done,
is it
a. just as straight forward as a engine oil change?
b. more ocmplicated because of the removing of interior bits?
or c. shouldn't be tried unless instructed or supervised?
or does any one care to share the steps?
cheers,
"No problem can be solved from the same level of consciousness that created it".
- Albert Einstein
- Albert Einstein
i beleive its the same as engine oil. undo the bolt at the bottom, oil comes out. however getting the oil back in is a bit trickier, for obvious reasons. i think there is a bolt on the side of the box, alongside the underside of the car, that you use to fill it back up. the only problem is to get the oil in, you'll need to pump it in (syringe) or run a hose to it, hold the other end of the hose upright by the side of the car and fill it from there.DJ_NoVa wrote:How would on change gearbox oil...
never done it and never seen it done,
is it
a. just as straight forward as a engine oil change?
b. more ocmplicated because of the removing of interior bits?
or c. shouldn't be tried unless instructed or supervised?
or does any one care to share the steps?
cheers,
_
_________________
_________________
I had that vibration in my silver car when I first got it.
I had no idea what it was so off to the mechanic. They said most likely a stuffed engine mount. It turned out to be that one of the belts to the balance shaft had skipped off at one end, or it skipped a few teeth and wasn't in the right position to the rest of the engine.
It was a few years back now.
The dude I bought it from covered it up by having his hand on the gear stick
I had no idea what it was so off to the mechanic. They said most likely a stuffed engine mount. It turned out to be that one of the belts to the balance shaft had skipped off at one end, or it skipped a few teeth and wasn't in the right position to the rest of the engine.
It was a few years back now.
The dude I bought it from covered it up by having his hand on the gear stick
- Cookiemonster
- Mother Goose
- Posts: 3177
- Joined: Thu Jan 08, 2004 4:33 pm
- Location: Sydney
Without ENGINE balance shafts the vibration will be transferred through the gearbox and the gearstick will rattle like crazy.SIRIUS wrote:cookie can you also get an extra 20hp from removing gearbox balance shafts....LOL....u make me laugh
Last edited by Cookiemonster on Tue Aug 03, 2004 10:55 pm, edited 1 time in total.
-
- almost postwhore
- Posts: 1015
- Joined: Sat Jan 10, 2004 12:02 pm
- Location: Ballarat, Victoria, Australia
- Contact:
Same shit gadget
Yeah im always holding the gear knob to stop it hell vibrating n making that hella annoying noise. did u fix it yourself? how easy was it?
Who is online
Users browsing this forum: No registered users and 23 guests