Guard Repair
-
- my mangina paid for my staz
- Posts: 2129
- Joined: Thu Jan 15, 2004 1:23 pm
- Location: Brisbane
Guard Repair
My tyres delaminated on the dyno and did this damage, is it repairable? If so who in Brisbane would be the best contact?
PS if you are running old tyres, throw them away, these ones were 9 years old but had plenty of tread.
PS if you are running old tyres, throw them away, these ones were 9 years old but had plenty of tread.
-
- racking my brains
- Posts: 5900
- Joined: Thu Oct 06, 2005 10:46 pm
- Location: sunshine coast qld
- Contact:
Yep Camerons is the go
Fibreglass airdams $370, fibreglass front bumpers $260, reco drag links $165, alloy radiators $925 (unpolished), h/l switch rebuilds $125, all plus freight.
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q
www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q
www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
-
- racking my brains
- Posts: 5900
- Joined: Thu Oct 06, 2005 10:46 pm
- Location: sunshine coast qld
- Contact:
Yep Camerons is the go
Fibreglass airdams $370, fibreglass front bumpers $260, reco drag links $165, alloy radiators $925 (unpolished), h/l switch rebuilds $125, all plus freight.
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q
www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q
www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
Rubber will harden and crack over time. This is true whether it is in tyres or engine mounts or anything else. The cracks may be internal and not visible to the eye
http://www.carbibles.com/tyre_bible.html
If the expiry date of a tyre is 6 years from manufacture, I wouldn't buy tyres that are more than 4 years old if I expect the tyre to last 2 years..
http://www.carbibles.com/tyre_bible.html
If the expiry date of a tyre is 6 years from manufacture, I wouldn't buy tyres that are more than 4 years old if I expect the tyre to last 2 years..
quest wrote:don't try explaining that to her tho..... just leave. lolWANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
Yep, it happens more often than you would think.
The Forum Parts Guy
www.vibrantperformance.com for all your performance fabrication needs
IRS OUTLAW, 2.3L VR4 Powered X235 Drag Car
Here to run out of your life & take all your money!
www.vibrantperformance.com for all your performance fabrication needs
IRS OUTLAW, 2.3L VR4 Powered X235 Drag Car
Here to run out of your life & take all your money!
-
- Austarion Occupant
- Posts: 3578
- Joined: Tue Apr 06, 2004 1:21 pm
- Location: Melborno
- Contact:
In the tyre bible (thanks Mamun!)something quite fascinating that most people wouldn't get to know about:
A note on the ZR rating: most speed ratings designate the speed that should not be exceeded. For example W-rated tyres are rated up to 270km/h. ZR-rated tyres, by comparison, are theoretically rated for anything over 240km/h. This is why the Bugatti Veyron was shod with ZR-rated tyres for the world record speed run of 431km/h when Top Gear drove it at the VW Ehra-Lessien test track. Although to be honest, at that speed the tyres only lasted for 8 minutes.
Holy smoke!
A note on the ZR rating: most speed ratings designate the speed that should not be exceeded. For example W-rated tyres are rated up to 270km/h. ZR-rated tyres, by comparison, are theoretically rated for anything over 240km/h. This is why the Bugatti Veyron was shod with ZR-rated tyres for the world record speed run of 431km/h when Top Gear drove it at the VW Ehra-Lessien test track. Although to be honest, at that speed the tyres only lasted for 8 minutes.
Holy smoke!
Reduce fuel costs by 15-20% & cut emissions by 1/3rd...
Increase engine performance & prolong engine life...
How?
Click the website button below & watch the 3 minute video.
Increase engine performance & prolong engine life...
How?
Click the website button below & watch the 3 minute video.
Unrepairable Tyre
RiceThief
I have seen quite a few tyres that looked like yours and about 90% of the time there was a reason like previous damage to the belt or a nail. When you get a replacement ask them to have a feel around the inside of your tyre with a rag and see if they can find anything.
P.S. I am aware that you were talking about the guard , not the tyre but when I saw the picture I nearly :cry: because I thought it was that sad to see and I wanted to look at it in a less serious way.
Look, I hate to tell you this but there is no way that tyre is repairable. I worked as a tyre fitter some years ago and I can say with 100% certainty that it is not repairable. Just buy a couple of new tyres.My tyres delaminated on the dyno and did this damage, is it repairable? If so who in Brisbane would be the best contact?
I have seen quite a few tyres that looked like yours and about 90% of the time there was a reason like previous damage to the belt or a nail. When you get a replacement ask them to have a feel around the inside of your tyre with a rag and see if they can find anything.
P.S. I am aware that you were talking about the guard , not the tyre but when I saw the picture I nearly :cry: because I thought it was that sad to see and I wanted to look at it in a less serious way.
Yea, ouch!!!
Seen that happen to retreaded tyres mostley.
Ones had a Colt with retreaded whinter-tyres that collapsed... (tyres, not the car!)
I have driven on tyres a lot older then 9 years... not so very good...
They get very hard, cracks and very very slippery. Especialy when wet!
(Can be fun though)
Good luck with the guard-repair!
Seen that happen to retreaded tyres mostley.
Ones had a Colt with retreaded whinter-tyres that collapsed... (tyres, not the car!)
I have driven on tyres a lot older then 9 years... not so very good...
They get very hard, cracks and very very slippery. Especialy when wet!
(Can be fun though)
Good luck with the guard-repair!
Who is online
Users browsing this forum: No registered users and 10 guests