Decided to swap over the broken indicator wiper in my JD with the one I recently acquired (thanks Moz).
They obviously changed the plug that attaches to loom by the time JDs came along so now I have to work out how to get the black one to match up to the socket for the JD one in the loom (blue one).
Does anyone know what type of socket the blue one is so I can re-do the black one to fit?
Do the wire colours match up between the two models? I see the plugs have the same number of pins. If so, I'd de-pin the old blue connector, snip all the pins off with a bit of wire still attached, snip the black plug off the new switch and match them up colour for colour. Solder on the pins from the blue connector, heatshrink, recover the loom, and job done?
