Rodney's twincam thread

ProZac · Post by **ProZac** » Mon Sep 02, 2013 6:34 am

Looks awesome! Did you get your tacho going? There is an even easier way if you're using a standard evo 1-3 ignition module with a tach output pin :-).

1320ft · Post by **1320ft** » Mon Sep 02, 2013 8:20 am

Looks killer.

Nice photography btw.

I really need to learn how to do vriginetting in photoshop

rodney007 · Post by **rodney007** » Mon Sep 02, 2013 7:41 pm

ProZac wrote:Looks awesome! Did you get your tacho going? There is an even easier way if you're using a standard evo 1-3 ignition module with a tach output pin :-).

hey, didn't manage to get it to read correctly yet, Steve sent me a tacho interface thingy which i connected up but didn't seem to give any signal to the tacho.

enthuzed · Post by **enthuzed** » Mon Sep 02, 2013 11:53 pm

rodney007 wrote:cool!... but looks bit hard for me :-)

Based on what you've done in that engine bay Rodney, a smidge of electronics fully spelt out for you will be a piece of piss!

ProZac · Post by **ProZac** » Tue Sep 03, 2013 12:25 pm

Hmmmm, tacho interface modules are usually pretty fail-safe... Do you have a digital dash in that car perchance?

hoongirl · Post by **hoongirl** » Wed Sep 04, 2013 5:48 pm

1320ft wrote:I really need to learn how to do vriginetting in photoshop

Go to filter > lens correction (CS6)
Under the custom tab there is a vignette box with two sliders
Adjust and enjoy

rodney007 · Post by **rodney007** » Fri Sep 06, 2013 7:04 pm

hoongirl wrote:
1320ft wrote:I really need to learn how to do vriginetting in photoshop
Go to filter > lens correction (CS6)
Under the custom tab there is a vignette box with two sliders
Adjust and enjoy

I think he was being sarcastic :-P

Austarion

Rodney's twincam thread

Who is online