1UZ in Starion
-
- my mangina paid for my staz
- Posts: 2129
- Joined: Thu Jan 15, 2004 1:23 pm
- Location: Brisbane
1UZ in Starion
I found this poking around SQC, theres a couple of vids on page 3, sounds sweet. http://www.starquestclub.com/forum/inde ... 24391&st=0
It did make me wonder if 4gbeat has finished his conversion.
Edit: Yay I hit 2000 posts.
It did make me wonder if 4gbeat has finished his conversion.
Edit: Yay I hit 2000 posts.
That was something I always wanted to do
I seen a Toyota V12 for sale, slightly narrower then a 1UZ, and about 2 inches longer then a 1JZ (which I have also seen in a Starion) so should possibly fit.
Might not be the best performing motor, but would be awesome just to have.
I seen a Toyota V12 for sale, slightly narrower then a 1UZ, and about 2 inches longer then a 1JZ (which I have also seen in a Starion) so should possibly fit.
Might not be the best performing motor, but would be awesome just to have.
Sold - 1987 Mitsubishi Starion GSR V DASH
Current - 1995 Subaru Legacy TT SW
- 1983 Mitsubishi Starion
Current - 1995 Subaru Legacy TT SW
- 1983 Mitsubishi Starion
jizzzz in my pants :pimp
if only there was room for a turbocharged one, without having to hack up most of the front of the car!
if only there was room for a turbocharged one, without having to hack up most of the front of the car!
quest wrote:don't try explaining that to her tho..... just leave. lolWANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
thrash wrote:jizzzz in my pants :pimp
if only there was room for a turbocharged one, without having to hack up most of the front of the car!
The Forum Parts Guy
www.vibrantperformance.com for all your performance fabrication needs
IRS OUTLAW, 2.3L VR4 Powered X235 Drag Car
Here to run out of your life & take all your money!
www.vibrantperformance.com for all your performance fabrication needs
IRS OUTLAW, 2.3L VR4 Powered X235 Drag Car
Here to run out of your life & take all your money!
Twin charged 1uz's are better than one!thrash wrote: if only there was room for a turbocharged one, without having to hack up most of the front of the car!
This car has gone 8.31, driven to the track and driven home. Runs on pump E85, full exhaust, steel guards & bonnet, engineered & rta approved!
http://www.youtube.com/watch?v=NAlHNSh7hC0
The Forum Parts Guy
www.vibrantperformance.com for all your performance fabrication needs
IRS OUTLAW, 2.3L VR4 Powered X235 Drag Car
Here to run out of your life & take all your money!
www.vibrantperformance.com for all your performance fabrication needs
IRS OUTLAW, 2.3L VR4 Powered X235 Drag Car
Here to run out of your life & take all your money!
Here you go :)
http://www.starquestclub.com/forum/inde ... 4391&st=20
And if you have some great fabrication skills try this an LS1 swap
http://www.starquestclub.com/forum/inde ... 145&st=180
http://www.starquestclub.com/forum/inde ... 4391&st=20
And if you have some great fabrication skills try this an LS1 swap
http://www.starquestclub.com/forum/inde ... 145&st=180
I've had mine since 03 07 92
85 JB 2323cc DOHC 4G63
THE OLDER I GET THE FASTER I WAS
GROWING OLD IS MANDATORY GROWING UP IS OPTIONAL
85 JB 2323cc DOHC 4G63
THE OLDER I GET THE FASTER I WAS
GROWING OLD IS MANDATORY GROWING UP IS OPTIONAL
Aaron, rule of thumb - all turbo V motors MUST be twin. If it's single it's not done right!
Rad, the pictures show it's a fairly tight fit - you could put two turbos in there, but you will most likely have reliability issues due to an very hot engine bay with tight clearances - it's definately doable.. but i think must be designed right for longevity. Also, the LS1 is actually smaller in size, albeit possibly heavier
Rad, the pictures show it's a fairly tight fit - you could put two turbos in there, but you will most likely have reliability issues due to an very hot engine bay with tight clearances - it's definately doable.. but i think must be designed right for longevity. Also, the LS1 is actually smaller in size, albeit possibly heavier
quest wrote:don't try explaining that to her tho..... just leave. lolWANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
Aaron's vid post is a capri, not a torana.
I was at a drag meet a while ago (between 5 and 10 years as a ball park) and there was an ra28 celica with apparently a stock long motor 1uz and twin turbos. Mostly stock body and interior with a simple cage, auto and big diff with slicks and was easily running into the 9's. I remember having a good look at it in the pits and it was pretty cramped in the engine bay but not too extreme. I heard the car was crashed not long after.
Having owned a 4cl turbo ta22 celica in the past I doubt the slightly longer ra28 bay is as wide as a starion. Probably not a simple street setup for a starion but it should be doable for a racer
I was at a drag meet a while ago (between 5 and 10 years as a ball park) and there was an ra28 celica with apparently a stock long motor 1uz and twin turbos. Mostly stock body and interior with a simple cage, auto and big diff with slicks and was easily running into the 9's. I remember having a good look at it in the pits and it was pretty cramped in the engine bay but not too extreme. I heard the car was crashed not long after.
Having owned a 4cl turbo ta22 celica in the past I doubt the slightly longer ra28 bay is as wide as a starion. Probably not a simple street setup for a starion but it should be doable for a racer
jb - white outside maroon inside
I know/remember that car.jk wrote:Aaron's vid post is a capri, not a torana.
I was at a drag meet a while ago (between 5 and 10 years as a ball park) and there was an ra28 celica with apparently a stock long motor 1uz and twin turbos. Mostly stock body and interior with a simple cage, auto and big diff with slicks and was easily running into the 9's. I remember having a good look at it in the pits and it was pretty cramped in the engine bay but not too extreme. I heard the car was crashed not long after.
Having owned a 4cl turbo ta22 celica in the past I doubt the slightly longer ra28 bay is as wide as a starion. Probably not a simple street setup for a starion but it should be doable for a racer
He now owns a killer turbo camaro.
The Forum Parts Guy
www.vibrantperformance.com for all your performance fabrication needs
IRS OUTLAW, 2.3L VR4 Powered X235 Drag Car
Here to run out of your life & take all your money!
www.vibrantperformance.com for all your performance fabrication needs
IRS OUTLAW, 2.3L VR4 Powered X235 Drag Car
Here to run out of your life & take all your money!
the space difference in the engine bay between a ta22 and an ra23 onwards is vastly different I am told by a celica expert - what will fit in an ra23 will not fit in a ta22, so unfortunately comparing the ta22 engine bay to the starion isn't the same as comparing the ra23+ engine bays with the starion bay
quest wrote:don't try explaining that to her tho..... just leave. lolWANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
Thrash, I think "vastly different" is a little exagerated, particularly in width, and more a matter of perspective from celica owners. I still highly doubt the ra28 bay is as wide as a starions, which was my intended point.
It's off topic anyway, no one here is thinking of putting a twin turbo v8 into a celica. My point was more that it has been done to small cars before, the example I witnessed had very little sheetmetal mods.
It's off topic anyway, no one here is thinking of putting a twin turbo v8 into a celica. My point was more that it has been done to small cars before, the example I witnessed had very little sheetmetal mods.
jb - white outside maroon inside
Who is online
Users browsing this forum: No registered users and 54 guests