M&W Ignitions?
M&W Ignitions?
Guys,
Any idea what is happening with M&W Ignitions? www.mwignitions.com
I tried to access their website but it is down. Are they still going?
My M&W twin coil packs (running wasted spark) look like they need to be replaced. The car is going for a tune in 5 days so I need to sort this ASAP.
Cheers,
Pete
Any idea what is happening with M&W Ignitions? www.mwignitions.com
I tried to access their website but it is down. Are they still going?
My M&W twin coil packs (running wasted spark) look like they need to be replaced. The car is going for a tune in 5 days so I need to sort this ASAP.
Cheers,
Pete
1985 JB Starion #157
Weird...RiceThief wrote:Site works fine from my computer.
Is there a contact phone number and email address on their website?
****************************************
I get a my Malwarebytes program is detecting a problem with it...
![Image](http://i819.photobucket.com/albums/zz112/austarion/TOMSUN/Picture1mampw_zpsa1a376cc.jpg)
****************************************
Unable to connect
Firefox can't establish a connection to the server at www.mwignitions.com.
The site could be temporarily unavailable or too busy. Try again in a few
moments.
If you are unable to load any pages, check your computer's network
connection.
If your computer or network is protected by a firewall or proxy, make sure
that Firefox is permitted to access the Web.
****************************************
Coils look like they need a replacement...
![Image](http://i819.photobucket.com/albums/zz112/austarion/TOMSUN/MampWcoilpacks_zps54b152b1.jpg)
1985 JB Starion #157
Yes, I probably could but for a bit over $200 for new coils and $20 for leads I think it will be one less thing to worry about when chasing power and reliability.Alspos wrote:Can you get a small wire brush in there and clean the shit out instead of replacing them? They look a tad neglected.
I might clean them up and stick them on ebay of a couple of bucks, might be good for someones project.
1985 JB Starion #157
I agree. very annoying trying to chase ignition bugs whilst on the dyno. Time = money and dyno operators aren't cheap :D
Been there and done that when tuning my GTR last year. Ended up replacing the complete ignition set up whilst on the dyno.
Best of luck, Pete :)
Who is doing the tuning?
Been there and done that when tuning my GTR last year. Ended up replacing the complete ignition set up whilst on the dyno.
Best of luck, Pete :)
Who is doing the tuning?
Please register your vehicle details on the AUSTRALIAN STARION REGISTRY <HERE>
1 x 3.2T
1 x 2.8T
3 x 2.6T's
1 x 2.0T
1 x 3.2T
1 x 2.8T
3 x 2.6T's
1 x 2.0T
^ Adam from JEM Tuning at Ingleburn will be doing a re-tune. He tuned it about 3 years ago. Only changes is a different turbo they have quoted 2 hrs for a retune and a bit of extra boost. Hoping everything holds together. :D
Out of interest, in the photo above the coil pack on the LHS is a M&W, the one RHS is a different brand. The terminals on the M&W appear to have held up better the abuse (arcing and potential water ingress).
Out of interest, in the photo above the coil pack on the LHS is a M&W, the one RHS is a different brand. The terminals on the M&W appear to have held up better the abuse (arcing and potential water ingress).
1985 JB Starion #157
Last time it made 146rwkw on 14psi. It should make about the same as I haven't changed any of the internals. Actually I have better exhaust so that might help a little. Should be interesting.NXTIME wrote:Ah yes, of course, JEM. :beer
What power are you hoping for?
Looking to tune it up to 24psi then wind it back to 20psi for daily.
So hope for:
150rwkw at 14psi, and ???
185rwkw at 20psi ??
200rwkw at 24psi ??
As long as it doesn't go bang :D
It did a 14.5 quarter mile before. I'd like to do a low 13. As quick as Rezone's orange JA would be a bonus. http://forums.austarion.com/viewtopic.php?t=7030
1985 JB Starion #157
Who is online
Users browsing this forum: No registered users and 17 guests