Roll centre adjusters

OLD FART · Post by **OLD FART** » Sun Jan 06, 2013 5:45 am

Any info good or otherwise appreciated.Would be good if someone had a set gathering dust and wanted to sell them.

RiceThief · Post by **RiceThief** » Mon Jan 21, 2013 9:36 pm

Rad are you still after a set? Im looking at buying some from techno toys as they have 35mm available.

OLD FART · Post by **OLD FART** » Tue Jan 22, 2013 4:20 am

RiceThief wrote:Rad are you still after a set? Im looking at buying some from techno toys as they have 35mm available.

You are a mind reader as TT were on my list to see if they had any to fit the JB
Don't know if 35mm is ok or not as will need to check ball joint to rim clearance especially IF I still want to be able to fit/use the stock 15's occasionally.What price are they?

RiceThief · Post by **RiceThief** » Tue Jan 22, 2013 8:30 am

Rad you wont be able to run these with 15s, I understand Techno Toys can machine them for clearance but then it defeats the purpose of running rca. Price is $90 plus shipping which is $25.

thrash · Post by **thrash** » Tue Jan 22, 2013 4:02 pm

how would one figure out where the best roll centre position is for a given car in real life?

OLD FART · Post by **OLD FART** » Tue Jan 22, 2013 5:18 pm

[quote="RiceThief"]Rad are you still after a set? Im looking at buying some from techno toys as they have 35mm available.[/quote
Yes I am .At present my LCR's are level so on bump or heavy braking they will not be in the best position.I will check the Ball joint clearance with 15's to see exactly how thick/high I can have and still fit the 15's .
Can get them machined if needed.

RiceThief · Post by **RiceThief** » Tue Jan 22, 2013 10:03 pm

thrash wrote:how would one figure out where the best roll centre position is for a given car in real life?

It would be where your suspension a full compression, the lower control arm not passing the horizontal mark.

Rad so would you like me to order two?

thrash · Post by **thrash** » Tue Jan 22, 2013 10:11 pm

RiceThief wrote:
thrash wrote:how would one figure out where the best roll centre position is for a given car in real life?
It would be where your suspension a full compression, the lower control arm not passing the horizontal mark.

Thanks!

OLD FART · Post by **OLD FART** » Wed Jan 23, 2013 5:07 am

Yer please Bao :)

Lummy · Post by **Lummy** » Fri Jan 25, 2013 3:02 pm

How often do you drive with your suspension at full compression? Far better off having a horizontal LCA at about the mid-point of the suspension movement.

OLD FART · Post by **OLD FART** » Fri Jan 25, 2013 4:43 pm

Lummy wrote:How often do you drive with your suspension at full compression? Far better off having a horizontal LCA at about the mid-point of the suspension movement.

They are dead level sitting in the garage with zero load so what you said^^^ is what I am trying to achieve. :)

RiceThief · Post by **RiceThief** » Fri Jan 25, 2013 9:41 pm

Lummy wrote:How often do you drive with your suspension at full compression? Far better off having a horizontal LCA at about the mid-point of the suspension movement.

Fair enough, I was only making an assumption.

Rad I've order them so I will let you know when they arrive.

Austarion

Roll centre adjusters

Roll centre adjusters

Who is online