Turbo oil supply thread?

All technical questions and answers regarding starions, being modifications to maintenance.
Post Reply
ProZac
G33Kz0r
Posts: 2674
Joined: Thu Nov 27, 2003 1:26 pm
Location: Christchurch, New Zealand
Contact:

Turbo oil supply thread?

Post by ProZac »

I'm putting together the order for the bits to fit the td05h to my Starion. The oil supply is baffling me a little...

The turbo has an M12x1.25 thread, which seems fairly generic, and is nice and easy to get AN adaptors for.

The supply from the oil filter housing has me a little stumped however. Ive circled the stock supply line in red in the picture below. Ideally I'd like to do away with the adaptor that's in place, and replace it with a -4AN adaptor, to match the turbo side. Can anyone tell me what the thread in the oil filter housing is here? (not the flare adaptor screwed in). It's tapered, if that helps.

Image

I really need to study up on threads other than nice simple metric ones!
User avatar
1320ft
almost postwhore
Posts: 1071
Joined: Mon May 03, 2010 8:33 pm
Location: St Andrews NSW

Post by 1320ft »

Just take the flare adaptor down to Pirtek & they will be able to tell you what thread it is.

"Shameless plug"

They stock our Proflow fittings, so they should have what you need.
The Forum Parts Guy

www.vibrantperformance.com for all your performance fabrication needs

IRS OUTLAW, 2.3L VR4 Powered X235 Drag Car

Here to run out of your life & take all your money!
ProZac
G33Kz0r
Posts: 2674
Joined: Thu Nov 27, 2003 1:26 pm
Location: Christchurch, New Zealand
Contact:

Post by ProZac »

Very punny :).

Cheers, they even have a local outlet, will go see them tomorrow.
fugazi
Enthusiast
Posts: 716
Joined: Thu Oct 02, 2008 10:30 pm
Location: Stockholm, Sweden
Contact:

Post by fugazi »

Image
ProZac
G33Kz0r
Posts: 2674
Joined: Thu Nov 27, 2003 1:26 pm
Location: Christchurch, New Zealand
Contact:

Post by ProZac »

Yeah, I found that thread, but it doesn't really give any answers.

I took some measurements, and came up with 1/4 NPT, going off this information:

http://www.fairburyfastener.com/xdims_pipe_threads.htm

It all seems to measure out okay, just over 1/2" at the thick end, and 18 TPI.

I've ordered line and the fittings from http://www.nzkw.com/

If it turns out to be something other than 1/4 NPT, I'll only have to get another adaptor to -4AN, but it was only like $4.50 anyway :).
coop1er
I've been here before
Posts: 240
Joined: Sat Feb 14, 2004 3:36 pm
Location: Adelaide

Post by coop1er »

Japanese tapered threads are usually bspt.
Post Reply

Who is online

Users browsing this forum: No registered users and 13 guests