WANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
don't try explaining that to her tho..... just leave. lol
how blown is blown? Guessing it's a 4G92 or 4G93? if so is it the common leaking oil out the side of the block above the bellhousing? Or more serious blow?
I seriously doubt you CAN blow the headgasket on a (standard, non modified) 4g92...
Considering how I drive mine.... LOL
A frrrkn nice 'n economical daily!!!!
My offer is 500AUD landed.... sorry but we have a shitload of those here an prices are low as. Well... I'm not realy sorry, c'us I'm happy with our's!
Nice looking though... no rust on the opposite of our's...
I've converted mine to E85 with 240cc injectors and som more ignition and it averages about 7,5-8,5 liters on 100km....
thrash wrote:really? ANY offer? is it registered still?
rego ran out in MAY its still actually regoed in shannon (www.18u) name
dirtygalant wrote:how blown is blown? Guessing it's a 4G92 or 4G93? if so is it the common leaking oil out the side of the block above the bellhousing? Or more serious blow?
its a 4G92, and your spot on its leaking oil out the site above the bell housing!
thrash wrote:really? ANY offer? is it registered still?
rego ran out in MAY its still actually regoed in shannon (www.18u) name
dirtygalant wrote:how blown is blown? Guessing it's a 4G92 or 4G93? if so is it the common leaking oil out the side of the block above the bellhousing? Or more serious blow?
its a 4G92, and your spot on its leaking oil out the site above the bell housing!
fugazi wrote:
My offer is 500AUD landed.... sorry but we have a shitload of those here an prices are low as. Well... I'm not realy sorry, c'us I'm happy with our's!
Nice looking though... no rust on the opposite of our's...
Id sell you them if it was easy enough to ship a non running car overseas
iXNAY wrote:its a 4G92, and your spot on its leaking oil out the site above the bell housing!
Isn't it more common to leak on the "belt"-side?
Mine is....
Can happen both sides but it's mostly common on the gearbox end due to the placement of the oil gallery. I suspect it's the 'second gen' 4G92/4G93 which swapped sides in the engine bay which has it happen on the belt side mostly.
The last 4G92 SOHC I did it on I just pulled the head off with manifolds still attached and cleaned up both surfaces with a block and sandpaper and assembled back together with a new gasket, timing belt and water pump and has been fine ever since. Was a sub $200 fix and took about 4 hours to do. If this wagon was in QLD I would snap it up for sure!