Huge fuel consumption problem

All technical questions and answers regarding starions, being modifications to maintenance.
User avatar
Kremmen
[P] Plater austaz
Posts: 20
Joined: Sat Oct 30, 2004 1:23 pm
Location: Melbourne
Contact:

Huge fuel consumption problem

Post by Kremmen »

My JA is now consuming well over twice as much fuel as it used to. It amazes me is that it's still running fine. In my experience, vast changes in fuel economy are usually accompanied by other changes in the way an engine performs but there are no obvious changes in power or anything. It just uses astronomical amounts of fuel.

The engine has been burning oil for some time (err, years) and this causes my mechanic's equipment to give totally bogus interpretations for the exhaust gasses. So, he said it could cost a fortune to try to diagnose the issue when none of their diagnostic equipment is useful.

I'd be really grateful if anyone has seen something like this before and has any idea what to check.
ProZac
G33Kz0r
Posts: 2674
Joined: Thu Nov 27, 2003 1:26 pm
Location: Christchurch, New Zealand
Contact:

Post by ProZac »

The typical reasons would be a chronically dirty air filter, or leaking injectors/injector seals.
User avatar
Kremmen
[P] Plater austaz
Posts: 20
Joined: Sat Oct 30, 2004 1:23 pm
Location: Melbourne
Contact:

Post by Kremmen »

I'm sure they checked the air filter and I'd guess that would get progressively worse, rather than happen really rapidly.

Is there any easy way to test leaking injectors/injector seals?
ProZac
G33Kz0r
Posts: 2674
Joined: Thu Nov 27, 2003 1:26 pm
Location: Christchurch, New Zealand
Contact:

Post by ProZac »

Take off the cross-over pipe (the pipe to your intake manifold, that goes over the rocker cover), and crank the car, watch the spray pattern of the injectors. Should be a fine mist, with no big drops. Once you stop cranking, there should be no dripping from the tip of the inejctors. Also, look for fuel flowing down the walls of the injection mixer, as that'll indicate a seal higher up.
User avatar
Kremmen
[P] Plater austaz
Posts: 20
Joined: Sat Oct 30, 2004 1:23 pm
Location: Melbourne
Contact:

Post by Kremmen »

Thanks. Mechanic says the throttle body/injectors/etc have had it and it would cost thousands to fix.
enthuzed
Austarion Occupant
Posts: 3578
Joined: Tue Apr 06, 2004 1:21 pm
Location: Melborno
Contact:

Post by enthuzed »

Sounds like another case of modification to aftermarket computer and MPI then. Or dump the car.

P.S. Hundreds is closer to the mark, your mechanic doesn't want to fix it, they are a pain in the arse but many on here have fixed theirs themselves...
Reduce fuel costs by 15-20% & cut emissions by 1/3rd...
Increase engine performance & prolong engine life...
How?
Click the website button below & watch the 3 minute video.
User avatar
Kremmen
[P] Plater austaz
Posts: 20
Joined: Sat Oct 30, 2004 1:23 pm
Location: Melbourne
Contact:

Post by Kremmen »

enthuzed wrote:P.S. Hundreds is closer to the mark, your mechanic doesn't want to fix it, they are a pain in the arse but many on here have fixed theirs themselves...
They not only don't want to fix it, they won't do it. They'd send it away to be fixed and charge whatever that comes to. Their only other economic recommendation is for me to find a good one from a wrecker, but that seems unlikely.
OLD FART
Austarion Occupant
Posts: 3448
Joined: Sun Jun 19, 2005 1:34 pm
Location: Brisbane

Post by OLD FART »

I have a pair of JA injectors for sale that have been tested and are not leaking if you want/need them.
I've had mine since 03 07 92
85 JB 2323cc DOHC 4G63
THE OLDER I GET THE FASTER I WAS
GROWING OLD IS MANDATORY GROWING UP IS OPTIONAL
ProZac
G33Kz0r
Posts: 2674
Joined: Thu Nov 27, 2003 1:26 pm
Location: Christchurch, New Zealand
Contact:

Post by ProZac »

Kremmen:

http://prozac.orconhosting.net.nz/eciguide/rebuild.html

They're really not that complicated. Its around $10 in parts, and maybe a day of your time, taking it super slow. Ive done a few now, and every single car has gone 100% better afterwards.

Shit, send it over to me, I'll rebuild it for you. Just have to hope your injectors are okay, could get them ultrasonically cleaned while the unit is apart.
User avatar
Kremmen
[P] Plater austaz
Posts: 20
Joined: Sat Oct 30, 2004 1:23 pm
Location: Melbourne
Contact:

Post by Kremmen »

Thanks a lot for the offers!

ProZac, I'd happily take you up on it if you were in Melbourne, but I'm not sure it's worth it as you're in NZ. ... Or at all, given the amount of smoke it blows. There are clearly other costly issues lurking in its future.
User avatar
Alspos
Flucking kwankers
Posts: 4107
Joined: Thu Jan 08, 2004 2:09 pm
Location: Melbourne
Contact:

Post by Alspos »

Where in Melb are you?
I think I have an injector top somewhere, take it, swap it over and see if it changes anything. If it's still running ok it may be a temperature sensor messing it up, thinking the ngine is always cold when it's warm.
User avatar
Kremmen
[P] Plater austaz
Posts: 20
Joined: Sat Oct 30, 2004 1:23 pm
Location: Melbourne
Contact:

Post by Kremmen »

Alspos wrote:Where in Melb are you?
I think I have an injector top somewhere, take it, swap it over and see if it changes anything. If it's still running ok it may be a temperature sensor messing it up, thinking the ngine is always cold when it's warm.
It idles normally, at higher revs when cold, so that aspect appears to be working. (The 35l/100km fuel consumption is a bit of an issue though.)

I'm in Box Hill.
mizuno man
Dorifto!
Posts: 55
Joined: Mon May 03, 2010 1:49 pm
Location: Brisbane

Post by mizuno man »

Have you checked for fuel leaks from the fuel pump to the engine bay. Can you smell any fuel?
User avatar
thrash
Austarion Occupant
Posts: 3028
Joined: Mon Apr 02, 2007 10:09 pm
Location: Sydney, Australia

Post by thrash »

Kremmen wrote:
I'm in Box Hill.
someone syphoning out your fuel perhaps rofl

do you smell fuel at any time within the car? if the running of the car hasn't changed, I would be checking the fuel tank and lines under the body to be sure there are no leaks or holes..
quest wrote:
WANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
don't try explaining that to her tho..... just leave. lol
seb
Big Dorifto
Posts: 74
Joined: Wed Nov 24, 2010 5:33 pm
Location: Ashford, Kent, England

Post by seb »

My Dad said he was driving his old nb years and years ago, started using huge amounts of fuel on one of his journeys, checked around and found a vacuum pipe had come away, think he said from somewhere near the bulkhead?? Worth a check, Seb
Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests