Custom inlet manifold..worth turning it?

enthuzed · Post by **enthuzed** » Sun May 20, 2012 12:07 am

http://www.sportsclassic.com.au/PartsSh ... 106&aid=11

bigmoz · Post by **bigmoz** » Sun May 20, 2012 10:17 am

the site looks pretty over priced

1320ft · Post by **1320ft** » Sun May 20, 2012 10:31 am

Same design as the Magnus/JNT by the looks of it.

I would get it

NXTIME · Post by **NXTIME** » Sun May 20, 2012 11:13 am

I agree. $500 plus $200-250 to cut and reweld = custom RWD 4G63 inlet.

Good to see Sportsclassic is still around - been at least 25 years?

fugazi · Post by **fugazi** » Sun May 20, 2012 5:44 pm

The JM-Fab intake is onley 510USD...

NXTIME · Post by **NXTIME** » Sun May 20, 2012 7:22 pm

add shipping and then cut/flip/reweld to suit RWD and it will end up being closer to $900.

fugazi · Post by **fugazi** » Sun May 20, 2012 8:21 pm

Nope! You can have it the right way if you want...

enthuzed · Post by **enthuzed** » Mon May 21, 2012 12:42 am

As fugazi said:

Also available is a RWD version of this manifold for no extra cost, perfect for the custom 4G63 swap into a rear wheel drive vehicle. If purchasing this version online be sure to specify during checkout in the "Comments" section.

Excellent find, better than what I found (by accident!)

NXTIME · Post by **NXTIME** » Wed May 23, 2012 12:56 am

Perfect :)

fugazi · Post by **fugazi** » Wed May 23, 2012 1:03 am

NXTIME wrote:Perfect :)

Yes, I know... I've got one!

NXTIME · Post by **NXTIME** » Wed May 23, 2012 8:10 pm

fugazi wrote:
NXTIME wrote:Perfect :)
Yes, I know... I've got one!

:beer

Pics?

fugazi · Post by **fugazi** » Wed May 23, 2012 9:45 pm

The pic's "clickable"... and about the onley I've got since I have'nt mounted any of anything on that motor.... yet!
What do you want to see?
I'll take som pic's...

Austarion

Custom inlet manifold..worth turning it?

Custom inlet manifold..worth turning it?

Who is online