http://www.gumtree.com.au/s-ad/granton/ ... 1000498456
Thanks
Autotecnica race seats SSP66BK L (pair) $400ono SOLD!!!
Autotecnica race seats SSP66BK L (pair) $400ono SOLD!!!
Last edited by Mick on Sat Mar 24, 2012 12:29 pm, edited 1 time in total.
FS: Ford 302ci Windsor. Race prepped block, Clevite bearings, ARP fixings, Hypertectic pistons, nitrided rods, knife edged crank, Gilmer drive, chrome moly rings, Yella Terra stage 3 heads, manly valves, Comp cams 294* solid roller, YT roller rockers, Funnelweb manifold, 2 inch spacer, Proform 830cfm carb, K&N 10" stack, ICE ignition. - 0437900210
I'd just like to vouch for Mick as a seller.
He even posted my item for free, and went to the effort of tracking it when i couldn't find it! Worse part was it had been delivered already, and was sitting in my lounge room, but no one in my family bothered to tell me it had arrived
Top Bloke in my book :beer
Now buy these seats peoples.....
He even posted my item for free, and went to the effort of tracking it when i couldn't find it! Worse part was it had been delivered already, and was sitting in my lounge room, but no one in my family bothered to tell me it had arrived
Top Bloke in my book :beer
Now buy these seats peoples.....
sold elsewhere but thanks for the plug mate... ive been jagged around that many times on postage and now refuse to put people in the same position :)
FS: Ford 302ci Windsor. Race prepped block, Clevite bearings, ARP fixings, Hypertectic pistons, nitrided rods, knife edged crank, Gilmer drive, chrome moly rings, Yella Terra stage 3 heads, manly valves, Comp cams 294* solid roller, YT roller rockers, Funnelweb manifold, 2 inch spacer, Proform 830cfm carb, K&N 10" stack, ICE ignition. - 0437900210
yeah it's a shame our postal service is third rate.
then again, i suppose most of the government services we have are crap, despite the high tax rates we pay.
then again, i suppose most of the government services we have are crap, despite the high tax rates we pay.
quest wrote:don't try explaining that to her tho..... just leave. lolWANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
yeah an mx5.
has a turbo kit and stuff, looked pretty trick, but the owner was a tool.
has a turbo kit and stuff, looked pretty trick, but the owner was a tool.
FS: Ford 302ci Windsor. Race prepped block, Clevite bearings, ARP fixings, Hypertectic pistons, nitrided rods, knife edged crank, Gilmer drive, chrome moly rings, Yella Terra stage 3 heads, manly valves, Comp cams 294* solid roller, YT roller rockers, Funnelweb manifold, 2 inch spacer, Proform 830cfm carb, K&N 10" stack, ICE ignition. - 0437900210
Who is online
Users browsing this forum: No registered users and 67 guests