Haltech e6k base map ?

filiboy · Post by **filiboy** » Tue Feb 28, 2012 6:05 am

Hello there ! Can somebody tell me where can I find base map for 4g63 starion ? simple setup - Sonata MPI with 450cc eclipse turbo injectors, Garrett gt25 turbocharger (similar in size to the stock one), ECU - Haltech e6k, or if there is another way to start the engine ? 10x a lot

Website · Post by **WidebodyWoody** » Tue Feb 28, 2012 9:48 am

Sorry have the g54 map for it. Hopefully someone else on here has one. I have a 63 twin cam map as well, but probably won't help much as it would still need changing.

MitsuMadness · Post by **MitsuMadness** » Thu Mar 22, 2012 12:48 pm

Here's an idea that may help you - since you're going to multipoint, you will need something for a similar capacity engine that has multipoint. The closest I believe would be a map for a 4G63T VR4 galant. They are also pretty common, so you are quite likely to find a map somewhere for that. I have VR4 galant maps for EMS computers, but not for a Haltech.

If you can find a VR4 map, that will be your best starting point, and then you will have to modify from there since your engine isn't actually a VR4 and will have slightly different flow and possibly different injector sizes etc.

When I did a Microtech on a GSR-V DASH engine recently, I actually used a map from a Mitsubishi Cordia as a starting point, cos they're similar, and throttle body injection (same as my DASH engine was) but a 1.8L engine, however I had also upgraded the size of my injectors. It was actually a really close match and I got the car running well enough to drive it to the dyno turner.

Basically if you find anything that's also 4 cylinder, and multipoint, that's a fairly good start. Even a Nissan SR20DET is not too different, just has different sensor settings etc.

Hopefully that helps!

MitsuMadness · Post by **MitsuMadness** » Thu Mar 22, 2012 12:49 pm

WidebodyWoody wrote:Sorry have the g54 map for it. Hopefully someone else on here has one. I have a 63 twin cam map as well, but probably won't help much as it would still need changing.

Yep - the twin cam 4G63 map would actually be a fairly good start for him (better than starting from scratch anyway) but yes as you say it will still need changing. Should get it running though.

Website · Post by **WidebodyWoody** » Thu Mar 22, 2012 1:58 pm

PM me with your email if you want the twin cam basemap then.

iXNAY · Post by **iXNAY** » Thu Mar 22, 2012 2:04 pm

Its your lucky day! i just found the map from my SOHC setup send me your email dude!

filiboy · Post by **filiboy** » Mon Mar 26, 2012 10:51 pm

Thank you all !! :beer , that starion forum is like a gift for starion owners

Austarion

Haltech e6k base map ?

Haltech e6k base map ?

Who is online