My twin cam build.

T-man · Post by **T-man** » Thu Mar 15, 2012 6:54 am

I thought I would put up a picture of my build so far! ( mock up stage )I've still to buy new pistons and shells. I've managed to use the starion water pump by modifing the pump and the tensioner. I'm in the middle of modding the oil pump as its not a direct fit. On wards and up wards!

T-man[/list]

OLD FART · Post by **OLD FART** » Thu Mar 15, 2012 7:08 am

Wide or narrow block ?
Max power wanted?
What gearbox?
Good luck as it can be character building and $$$$$$$$$$$$ :) been there done that LOL

T-man · Post by **T-man** » Thu Mar 15, 2012 7:50 am

Old fart, its a convertion buddy, Im converting the 8v sohc to the evo 3 16v DOHC, I'm using the evo 3 head, inlet manifold, exhaust manifold, wiring loom, turbo and evo 3 ecu. Everything else is starion. As for bhp I would like something like 280bhp-300bhp. The evo 3 has got hks pullys and some kind of uprated ecu. Ive thought about the increased stress on the clutch and have purchased a 4 paddle uprated clutch and a lightned and balanced flywheel. Have you carried out the convertion? If so have you any recommendations on which pistons and shells to use or any advice will be greatfully recived.

T-man

OLD FART · Post by **OLD FART** » Thu Mar 15, 2012 8:54 am

I have a 2323cc stroker with Eagle rods & Wiseco pistons + ACL Race Series bearings,ARP head & mains studs.
300 hp will have the box on the verge of breaking a few teeth so drive it accordingly :( :)

T-man · Post by **T-man** » Thu Mar 15, 2012 6:19 pm

Yeah, like I stole it! Yeah baby yeah, take it hard take it fast!!!!!!!

T-man :D

T-man · Post by **T-man** » Fri Mar 30, 2012 3:32 am

Look what the postman brought!!!!!!
Oh yeah shiney parts! Such a shame to hide them in the block.

T-man

Website · Post by **WidebodyWoody** » Fri Mar 30, 2012 9:28 am

Yeah, looks nice. I have CP 4G63 2.0 forged pistons I will need to sell soon to buy some wiseco bigger pistons for the 2.4 build. Nothing like hiding a nice set of pistons rofl

OLD FART · Post by **OLD FART** » Fri Mar 30, 2012 11:53 am

WidebodyWoody wrote:Yeah, looks nice. I have CP 4G63 2.0 forged pistons I will need to sell soon to buy some wiseco bigger pistons for the 2.4 build. Nothing like hiding a nice set of pistons rofl

Woody are you building a 64 or a 63 stroker :?

Website · Post by **WidebodyWoody** » Fri Mar 30, 2012 1:53 pm

64 so the 63 pistons are too small. Thought about the 63 stroker. If I can't see the CP pistons I may lean that way... But honestly, I think I prefer the 64 version anyway.

Austarion

My twin cam build.

My twin cam build.

Shiney parts!!!!!!

Who is online