turbo motor

davidbek95 · Post by **davidbek95** » Tue Aug 02, 2011 7:56 pm

Any of you guys that have a widebody starion want to sell there 4g54 turbo motor.That they have pulled out.
regards david

OLD FART · Post by **OLD FART** » Wed Aug 03, 2011 4:44 am

What are you up to now David :? :o

davidbek95 · Post by **davidbek95** » Wed Aug 03, 2011 9:14 pm

Well i am not sure yet,i want to stay single cam,i am giving myself a choice,between the starion 2litre or 4g64 or 4g54 build,as there is a drag car in mackay runs a 7seconds with a 4g54 engine with turbo in it,with no fancy stuff done internals.As my gearbox is good for 600hp,not sure what pajero diffs are good for.I would like a twin cam to much hassle regards david

1320ft · Post by **1320ft** » Wed Aug 03, 2011 9:29 pm

Yeah, but that is an altered that weighs sfa compared to a door car.

redzone · Post by **redzone** » Wed Aug 03, 2011 11:01 pm

what about an Isuzu 4ZE1 2.6 or 4ZD1 2.3L? they're a sohc that take even less to prep than a Mitsu and are bullet proof with a set of forgies, rods not needed either unless you're gonna rev it REALLY hard.. and no balance shafts! lol

davidbek95 · Post by **davidbek95** » Thu Aug 04, 2011 4:39 pm

No got to stick to the wide block mitsubishi,then i got another type of engine got to get another bellhouding and adaptor plate for the gearbox,etc.
regards david

NXTIME · Post by **NXTIME** » Thu Aug 04, 2011 5:37 pm

2.4L with 16V SOHC head?

Adriano · Post by **Adriano** » Fri Aug 05, 2011 2:01 pm

Ive got a 2.4 wide pattern with a 16v head if it is of interest, PM me.

bigmoz · Post by **bigmoz** » Fri Aug 05, 2011 2:36 pm

this one is on ebay

http://www.ebay.com.au/itm/Mitsubishi-S ... 1e65dd0199

Austarion

turbo motor

turbo motor

up to

ebay

Who is online