Distributor needed

Vulpes · Post by **Vulpes** » Wed Jun 29, 2011 1:59 pm

Help i need a dizzy, mine leaks like mad and the rpelacement i had on a parts car is the wrong one. I need the series two one with the lower cap. any help here ?

1320ft · Post by **1320ft** » Wed Jun 29, 2011 4:47 pm

I can try and get you a reco'd one.

But I need the numbers off the housing of the one that is leaking.

Lunacy · Post by **Lunacy** » Fri Jul 01, 2011 2:13 pm

Will a euro spec one fit it? From type 2 injection engine. Was working fine when removed. Pm me if interested

John196701 · Post by **John196701** » Fri Jul 01, 2011 7:07 pm

Vulpes
I do have one out of my JB, was working before i changed to multi-point

MrBishi · Post by **MrBishi** » Sat Jul 02, 2011 11:28 am

Can't you just whack a new seal in?

enthuzed · Post by **enthuzed** » Sat Jul 02, 2011 8:43 pm

Or replace just the vac unit?

Vulpes · Post by **Vulpes** » Sun Jul 03, 2011 6:44 pm

$450 for a new seal and o-ring , a bit rich me thinks.

MrBishi · Post by **MrBishi** » Mon Jul 04, 2011 2:03 pm

Leaking oil out the shaft or vacuum leak?
Oil seal & O-ring should be gettable from any bearing shop for under $10 for both. Pull it apart and take the old seal down.
I'm not full bottle on the G63 distributors, but assume they can be disassembled without destroying bits?

Vulpes · Post by **Vulpes** » Tue Jul 05, 2011 6:24 pm

Its all good, John came to the rescue, thanks mate it is all back in and running great Cheers.

Austarion

Distributor needed

Distributor needed

Who is online