Cos I'm building a shed. That's my excuse and I'm sticking to it.
This is where my tools are currently stored.
and this one just doesn't cut it
So......started digging holes and laying the groundwork for a new one
Moved the old shed outta the way
Boxed for concrete
Reo...
and finally a slab.
Then the frame work started. Back wall
and the other walls
then rafters, noggins and battens
Wrapped to provide a bit of protection
Then you put a roof on it
then spend a week painting the timber cladding for the outside
And I scored some wardrobe for nothing that will house some of my crap.
This is where it currently stands.....so progress will look a bit slow from now on.
Why my Staz isn't on the road
You needed an old fashioned amish shed building session.
Looks good. Planning on painting the floor?
Looks good. Planning on painting the floor?
The Forum Parts Guy
www.vibrantperformance.com for all your performance fabrication needs
IRS OUTLAW, 2.3L VR4 Powered X235 Drag Car
Here to run out of your life & take all your money!
www.vibrantperformance.com for all your performance fabrication needs
IRS OUTLAW, 2.3L VR4 Powered X235 Drag Car
Here to run out of your life & take all your money!
Looks great, Al. Don't forget to put some insulation on the inside before you sheet the walls for extra thermal protection :D
Please register your vehicle details on the AUSTRALIAN STARION REGISTRY <HERE>
1 x 3.2T
1 x 2.8T
3 x 2.6T's
1 x 2.0T
1 x 3.2T
1 x 2.8T
3 x 2.6T's
1 x 2.0T
Yep Charlie, west and north walls will get insulated to hopefully kill a bit of heat from direct sunlight.
Dunno about painting the floor as yet, I hopefully won't be spilling oil and crap working on cars in there, I'll just see how cruddy it gets.
Got a chance to hang some of the cladding panels. Bit awkward doing it alone but didn't come out too bad. Most awkward part is making sure the angles for the corners are plumb. Don't just assume the walls don't have any bows in them, guess how I figured that out
Need to make the door frame before I can finish off the last sheets. Then the high ones...not looking forward to that!
Dunno about painting the floor as yet, I hopefully won't be spilling oil and crap working on cars in there, I'll just see how cruddy it gets.
Got a chance to hang some of the cladding panels. Bit awkward doing it alone but didn't come out too bad. Most awkward part is making sure the angles for the corners are plumb. Don't just assume the walls don't have any bows in them, guess how I figured that out
Need to make the door frame before I can finish off the last sheets. Then the high ones...not looking forward to that!
Who is online
Users browsing this forum: No registered users and 38 guests