Why my Staz isn't on the road

A place for general discussion. Catch up with mates, post pics, or if you just want to pick on e-thugs.
Post Reply
User avatar
Alspos
Flucking kwankers
Posts: 4107
Joined: Thu Jan 08, 2004 2:09 pm
Location: Melbourne
Contact:

Why my Staz isn't on the road

Post by Alspos »

Cos I'm building a shed. That's my excuse and I'm sticking to it.

This is where my tools are currently stored.
Image

and this one just doesn't cut it
Image


So......started digging holes and laying the groundwork for a new one
Image

Moved the old shed outta the way
Image

Boxed for concrete
Image

Reo...
Image

and finally a slab.
Image


Then the frame work started. Back wall
Image

and the other walls
Image

then rafters, noggins and battens
Image

Wrapped to provide a bit of protection
Image

Then you put a roof on it
Image

then spend a week painting the timber cladding for the outside
Image

And I scored some wardrobe for nothing that will house some of my crap.
Image

This is where it currently stands.....so progress will look a bit slow from now on.
JDSTAZ45
almost postwhore
Posts: 1250
Joined: Sat Feb 12, 2005 10:00 pm
Location: Inner West, Sydney

Post by JDSTAZ45 »

Not a bad project....
You should drop by to Mitsumadness place and check out his set-up just installed. Truly amazing!

Wish I could do something similar but I got buckleys with council approving it on a small block of land!!

:beer
Imports.
88 GSR-VR Widebody 2.6L
87 GSR-V 12V Dash 2.0L
User avatar
1320ft
almost postwhore
Posts: 1071
Joined: Mon May 03, 2010 8:33 pm
Location: St Andrews NSW

Post by 1320ft »

You needed an old fashioned amish shed building session.

Looks good. Planning on painting the floor?
The Forum Parts Guy

www.vibrantperformance.com for all your performance fabrication needs

IRS OUTLAW, 2.3L VR4 Powered X235 Drag Car

Here to run out of your life & take all your money!
User avatar
NXTIME
Registry Nazi
Posts: 2972
Joined: Thu Jan 08, 2004 3:14 pm
Location: Sydney, NSW

Post by NXTIME »

Looks great, Al. Don't forget to put some insulation on the inside before you sheet the walls for extra thermal protection :D
Please register your vehicle details on the AUSTRALIAN STARION REGISTRY <HERE>


1 x 3.2T
1 x 2.8T
3 x 2.6T's
1 x 2.0T
User avatar
Alspos
Flucking kwankers
Posts: 4107
Joined: Thu Jan 08, 2004 2:09 pm
Location: Melbourne
Contact:

Post by Alspos »

Yep Charlie, west and north walls will get insulated to hopefully kill a bit of heat from direct sunlight.
Dunno about painting the floor as yet, I hopefully won't be spilling oil and crap working on cars in there, I'll just see how cruddy it gets.

Got a chance to hang some of the cladding panels. Bit awkward doing it alone but didn't come out too bad. Most awkward part is making sure the angles for the corners are plumb. Don't just assume the walls don't have any bows in them, guess how I figured that out
Need to make the door frame before I can finish off the last sheets. Then the high ones...not looking forward to that!

Image
Image
Post Reply

Who is online

Users browsing this forum: No registered users and 42 guests