Guys,
I need an ecu pinout for a uk spec 2.0t, any ideas?
http://projectzerog.com/wiring_info.shtml
Found this but it mentions injectors 3 and 4 so cant be right,
Steve
ecu pinout
Air flow signal - White/Black stripe (Air flow sensor output)
RPM - Not entitely sure on this one. If i remember correctly it takes the rpm signal off the coil, and if this is the case it is a White wire for coil.
Throttle - Lime Green/Black stripe (Reed switch) (Check with a multimeter though as there are 2 x wires this colour, the other is Intake Air Temp Sensor B)
+12v - Large (1.25) Red
Ground - Large (0.85) Black
Hope this helps, my eyes hurt reading that wiring diagram at this hour of the morning haha
RPM - Not entitely sure on this one. If i remember correctly it takes the rpm signal off the coil, and if this is the case it is a White wire for coil.
Throttle - Lime Green/Black stripe (Reed switch) (Check with a multimeter though as there are 2 x wires this colour, the other is Intake Air Temp Sensor B)
+12v - Large (1.25) Red
Ground - Large (0.85) Black
Hope this helps, my eyes hurt reading that wiring diagram at this hour of the morning haha
- deejaylg
- [P] Plater austaz
- Posts: 22
- Joined: Tue Dec 22, 2009 9:56 pm
- Location: Veresegyház, Hungary
From the menu at the top, go to technical section, download the American Conquest/Starion Manual zip file, and you can find some infos about ECUs in eciturbo-med.pdf.kushman wrote:Bump
So the second diagram down with the 2 connectors is for a uk ex?
any one got a pin out for ex euro ?
The pinouts are at page 39-41
'86 Mistubishi Starion 2.0T
Who is online
Users browsing this forum: No registered users and 0 guests