are these avaliable for starions anywhere?
looked at getting a set made up from an engineer but were pretty damn expensive
roll centre adjusters
juice_2 is selling a pair..
for the noobs here (a.k.a me), what do this roll centre things do?
for the noobs here (a.k.a me), what do this roll centre things do?
quest wrote:don't try explaining that to her tho..... just leave. lolWANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
I purchased a set of the mookeeh RCA's and they are only 15mm. I plan on using 16x8 rims on my car, and I read somewhere on the US forum that this is about the tallest you could go with 16" rims due to the tie rod hitting the wheel. If you were planning to use larger diameter rims you would have the clearance to run taller RCA's, so you may want to investigate custom units anyway.
Thrash - RCA's are just spacers that fit between the bottom of the strut and the ball joint, they restore some of the lost steering/suspension geometry after lowering (depends on ride height change and spacer thickness).
Thrash - RCA's are just spacers that fit between the bottom of the strut and the ball joint, they restore some of the lost steering/suspension geometry after lowering (depends on ride height change and spacer thickness).
jb - white outside maroon inside
-
Nosaki Faki
- I like starions
- Posts: 149
- Joined: Wed Mar 12, 2008 8:08 pm
- Location: Bendigo. Vic.
-
Komeuppance
- Enthusiast
- Posts: 607
- Joined: Fri Nov 16, 2007 3:50 pm
- Location: Oregon, USA
- Contact:
Who is online
Users browsing this forum: No registered users and 84 guests