Need a few bits for a motor im building

bigmoz · Post by **bigmoz** » Thu Mar 04, 2010 11:21 pm

hey people, six years on and the dream is still alive but its about to step up a level. im about to build my new motor and im looking for a few things

i have, full sonata multi setup with intercooler run by a microtech, ross forgies, new machined ported head, tdo6 20g

Block - previously unmachined to fit my pistons
CAM - non standard
injectors - 510cc etc
head gasket - what should i use? cometic what size etc

also i would like to know if anyone of you could recommend someone to make a custom exhaust manifold/dump in Melbourne

anything else you guys could recommend or would think is needed would be great

thank again
moz

iXNAY · Post by **iXNAY** » Thu Mar 04, 2010 11:37 pm

bigmoz wrote:anything else you guys could recommend or would think is needed would be great

Twin cam head :D

bigmoz · Post by **bigmoz** » Thu Mar 04, 2010 11:38 pm

iXNAY wrote: Twin cam :D

bitch

iXNAY · Post by **iXNAY** » Thu Mar 04, 2010 11:44 pm

bigmoz wrote:
iXNAY wrote: Twin cam :D
bitch

i seriously dont see why you dont, you pretty much have enough stuff to go that way anyway...

you have injectors to get u going.
you have to make a custom manifold anyway.
you have a aftermarket ECU.
all you need is the twincam head+rear water outlet+inlet manifold or modified VR4 inlet.

flav · Post by **flav** » Tue Mar 16, 2010 5:46 pm

have a block..its in my way, come get it

Austarion

Need a few bits for a motor im building

Need a few bits for a motor im building

Re: Need a few bits for a motor im building

Re: Need a few bits for a motor im building

Re: Need a few bits for a motor im building

Who is online