removing door cards and dash

Technical questions and ideas regarding how your Starion looks inside and out, bodykits to stereos.
Post Reply
fpv_escort
[P] Plater austaz
Posts: 24
Joined: Thu May 10, 2007 10:57 am
Location: tas

removing door cards and dash

Post by fpv_escort »

my brother is turning his JA starion into an improved production racecar. he has started stripping out the interior, all thats left is the dash and doors. is there an easy way to take these out without ruining them???
JD_Stazza_Brendan
almost postwhore
Posts: 1131
Joined: Tue Jan 25, 2005 10:46 pm
Location: Mackay, QLD, Australia

Post by JD_Stazza_Brendan »

Door trims are easy.

-Remove speakers in the door (if someone put them in there)
-Remove door handle grab (screw at top and screw at bottom)
-Undo the 2 screws holding the door light in and remove the wires from the back.
-There should be a small bolt on the upper rear of the door holding a little panel on, remove that and the panel will come off
-Take out the door handle trim (held in by 1 small screw)
-Using something like a butter knife, you can pry the upper section off first then the lower section after.
-JA Starion with JD bits , Forged engine, Heaps of mods (parked up)
-BFII XR6 Turbo Ute , Here comes 400hp for 2k :p
-77 Mazda 323 drag car. 13bt rotary project.

Yes i have too many toys.
SOHC POWER
NachoMan
nearly postwhore
Posts: 1589
Joined: Sat Jan 10, 2004 12:28 pm
Location: Perth (Morley), WA
Contact:

Re: removing door cards and dash

Post by NachoMan »

fpv_escort wrote:my brother is turning his JA starion into an improved production racecar. he has started stripping out the interior, all thats left is the dash and doors. is there an easy way to take these out without ruining them???
http://forums.austarion.com/viewtopic.php?t=2546
Post Reply

Who is online

Users browsing this forum: No registered users and 65 guests