HELP! my door trim is falling off

Technical questions and ideas regarding how your Starion looks inside and out, bodykits to stereos.
Post Reply
User avatar
thrash
Austarion Occupant
Posts: 3028
Joined: Mon Apr 02, 2007 10:09 pm
Location: Sydney, Australia

HELP! my door trim is falling off

Post by thrash »

My passenger's side door trim is hanging off near where the door opens.. when you open the door, the trim gets stuck against the rear seat surround trim..

I tried changing the little pin thingos that look like chess pawns, but even with the ones from my parts car it doesn't stay on..

how hard/expensive is this to fix?
quest wrote:
WANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
don't try explaining that to her tho..... just leave. lol
User avatar
Alspos
Flucking kwankers
Posts: 4107
Joined: Thu Jan 08, 2004 2:09 pm
Location: Melbourne
Contact:

Post by Alspos »

The door card itself may be rooted and the clips are falling out. Quick fix....self tappers. Once those clips are locked in they are hard to get out....perhaps you're not pressing them in hard enough.
User avatar
greenstaz82
Mine is bigger than yours
Posts: 275
Joined: Tue Nov 09, 2004 8:29 pm
Location: brisbane

Post by greenstaz82 »

if the clip housings are broken a bit of hot glue or sikaflex will do the job , sometimes also u can hide a small black headed screw in the lower section of the carpet .
decoy
Let Me Out!
Posts: 4424
Joined: Tue Sep 09, 2003 3:03 pm
Location: Far from home
Contact:

Post by decoy »

do the ones from your parts car not stay on because they're breaking or the actual wood from the door card isnt holding onto them anymore?

I'm using ones from holden, they seem to be a pretty standard thing for interior clips. holden ones were longer but no problems, brand new plastic so not brittle like the old ones.
_
_________________
User avatar
thrash
Austarion Occupant
Posts: 3028
Joined: Mon Apr 02, 2007 10:09 pm
Location: Sydney, Australia

Post by thrash »

the clips from my parts car seem fine.. i think it's the actually bits that the pin thingos go into that are no longer holding..

Thanks for the help everyone! I'll figure it out.. been too busy to bother with it for now.
quest wrote:
WANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
don't try explaining that to her tho..... just leave. lol
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests